Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Extrusions Inc, 2401 S Main St, FORT SCOTT, KANSAS 66701
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was resetting crimp plates and caught her left ring finger in the crimper head when it recessed into the machine causing a partial amputation of the fingertip.
The employee was punching small parts on the hydraulic punch press when a part got stuck. As she tried to pull the small part out of the punch press, the punch activated, smashing the end of her finger. The fingertip was amputated to just behind the fingernail.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 331318)
An employee was adjusting a stretcher. Their foot went between a 3-inch opening on a press. The employee sustained an open fracture of their lower left leg above the ankle.
An employee was standing at a press machine, removing metal from a die cradle that was stuck. Once the metal was removed, the side die closed on his right wrist and lower forearm, breaking bones in the arm.
An employee was pulling metal using a tail stretcher. He pressed the double palm buttons to start the process when the clamp became stuck. The employee pulled on the metal. His left thumb was inside the clamp when it opened, cutting and amputating the tip of his thumb.
An employee was operating a 2 1/2 inch extruder press when aluminum became jammed in the press. Pressure built up and the piece of aluminum shot into the employee's left index finger, resulting in hospitalization and surgery.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.