Exposure to environmental heat · Effects of heat and light, n.e.c.
At a glance
Federal OSHA recorded a severe workplace injury
at STX Beef Company, LLC, 9001 Leopard St, CORPUS CHRISTI, TEXAS 78409
on — Effects of heat and light, n.e.c., affecting the bODY SYSTEMS.
Final narrative
On June 3, 2019, an employee experienced heat stress/dehydration and was hospitalized.
An employee was spacing cow carcasses, which were suspended on the railing of a conveyor. A carcass came off the railing and fell to the killing floor. A shackle also fell off the conveyor, and it struck the middle of the employee's left foot and broke it.
An employee was stepping outside to check the chemical tote level when they slipped on a patch of ice and fell to the ground. The employee sustained an ankle fracture that required hospitalization.
An employee was operating an automated shank saw and was removing fat caught in the wheelhouse and small conveyor. The employee opened the wheelhouse assembly and went to remove the fat using a knife when the knife was caught. The employee's hand was pulled in and she sustained an amputation to the end of her right index finger.
An employee was performing finishing work on a residential driveway when they began to experience body cramps and were hospitalized for heat stress and dehydration.
An agent was participating in SWAT team selection and was performing various physical fitness skills including running and exercise intervals. The agent experienced dehydration and a muscular injury that required hospitalization.
On September 26, 2023, an employee was delivering packages when he began to feel ill with a pain in his side. He was hospitalized for heat exhaustion and dehydration.
More severe injuries in this industry (NAICS 311611)
An employee was scraping dried glue from the top lid of a hot glue pot. His left hand slipped and came into contact with the hot glue. He then suffered burns to his hands and fingers as he tried to remove the glue. He was hospitalized.
An employee was in a scissor lift approximately 20 feet above the ground to place a plastic tarp on a catwalk in order to catch condensation. They positioned the lift opposite the work area and stepped out of the scissor lift onto an I-beam. The employee fell from the I-beam to the ground. The employee was hospitalized with a skull fracture on the right side of their head and injuries to the chest and both eyes.
A maintenance employee was called to look at a pallet conveyor machine where a chain had fallen off a sprocket wheel. When the employee grabbed the loose chain, a light sensor caused the machine to restart. This created a pinch point between the chain and sprocket that caught the employee's left little finger. The finger was surgically amputated at the second knuckle.
The injured employee was standing by one of the stationary computers along the wall. There was a half-pallet located approximately 3 feet behind the employee that consisted of 12-pound boxes stacked six boxes high. A forklift was transporting a pallet that came in contact with the stationary pallet behind the injured employee, causing four boxes to fall and contact their legs. The injured employee was hospitalized with leg injuries.
An employee was using a box strapping machine to place straps on boxes when his right middle finger was caught in the machine, resulting in an open fracture to the distal phalanx.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.