Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at LABCONCO Corporation, 2500 Liberty Bell Rd, FORT SCOTT, KANSAS 66701
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was using a drill press with a hole saw bit installed, when the bit caught the employee's glove, pulling the employee's left thumb into the bit and resulting in an amputation (from the middle).
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332322)
An employee was driving a forklift when its right front wheel dropped off a 6-inch curb. The forklift rolled over and trapped him against the concrete surface. He suffered a broken pelvis, ribs, and collarbone, as well as a collapsed lung.
An employee was operating a brake press when the top die broke, causing the bottom die to roll out and onto the employee's legs. Both of the employee's legs were crushed below the knee, and both legs were partially amputated. The employee's left leg was also fractured above the knee.
An employee was performing routine maintenance on a shear machine when the machine's foot pedal was engaged and the blade contacted his right middle finger, resulting in a partial amputation.
An employee was helping to tighten down a metal packaging band for shipping. The metal band broke and struck the employee across their face, cutting their left face/eye area. The employee was hospitalized.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.