Injured by slipping or swinging object held by injured worker · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Champlin Tire Recycling, Inc., 2122 Rust Road, CONCORDIA, KANSAS 66901
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Watch Champlin Tire Recycling, Inc. — freeGet an email when a new federal OSHA severe-injury report for Champlin Tire Recycling, Inc. is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee operating a tire shredder was using a pry bar to free a jammed tire from the tire shredder's conveyor guard. The employee's hands became caught between the pry bar and the guard. The employee sustained four fractured metacarpal bones in the left hand and the right thumb was amputated and later reattached.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 562920)
An employee was working on a loading ramp that was stuck open (upright). The employee went under the ramp to release it. When he pulled on a chain that was holding the ramp open, the ramp came down rapidly, striking the right side of his face (cheek) and the right side of his neck. The employee was hospitalized.
An employee was cutting off bracing from an 8 x 12' metal wall when the wall fell, striking the employee on their side and back. The employee sustained bruised ribs and two fractures in their back.
A driver was climbing the rear trailer ladder to facilitate tarping when they lost balance, slipped, and fell approximately 6-8 feet to the ground. The employee sustained a fractured wrist.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.