105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Flex-Erect, LLC

Injured by slipping or swinging object held by injured worker · Amputations

Federal OSHA recorded a severe workplace injury at Flex-Erect, LLC, 1201 Lake Woodlands Drive, THE WOODLANDS, TEXAS 77380 on — Amputations, affecting the finger(s), fingernail(s), n.e.c..

Watch Flex-Erect, LLC — free Get an email when a new federal OSHA severe-injury report for Flex-Erect, LLC is published. One employer, no account, unsubscribe in one click.

An employee was utilizing a magnetic drill to drill holes in 1.5" tube. The employee was removing metal shavings and his glove was caught by the bit pulling his left hand into the drill. The drill amputated his index fingertip and thumb, and lacerated his middle finger.

Amputation Finger(s), fingernail(s), n.e.c. Drills-powered

Flex- Erect,LLC

An employee was going up on a lift. His hand was outside the lift railing, and his right index finger was caught between the railing and a steel erection. His fingertip was amputated.

Flex-Erect, LLC

An employee was transporting a structural steel roll on a cart when it tipped over. The structural steel then rolled back and crushed his toes on the right foot. He was hospitalized.

View Flex-Erect, LLC's full OSHA safety record →

Mako Contracting, LLC

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

East Penn Manufacturing

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

Ash Brothers Fireplace and Chimney Co

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

RPM & Associates Inc

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

Tenaris Hickman

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

Foundation Steel, LLC

An employee fell from a step ladder while reaching for a tie-off point. He impacted the ground, and landed on his bolt bag which contained tools. The employee was hospitalized with fractured ribs, and a lacerated spleen and kidney.

Red Dot Corporation

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

Cornell & Company, Inc.

An employee was standing on the surface of a steel beam about two feet wide. He slipped and fell backward, landing on the concrete ground about 20 feet below. The employee sustained a broken pelvis.

K Constructor, LLC

An employee was unloading a rebar delivery from a flatbed, 19-wheel trailer. The employee rigged the load with wire rope chokers. The load was picked up 3-4 feet above the trailer deck by a crane. The load began to swing and the employee grabbed onto it to prevent it from being pushed off the trailer deck. The crane continued to lift the load, and the employee let go so the crane did not lift him to the third story. The employee fell approximately 12 feet to the ground below, resulting in a back injury and fractured vertebrae.

Bowman Steel, LLC

An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.

T G Meat Center LLC

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

Professional Flooring Supply

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

EnviroSafe Demil LLC

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

Inteplast Group

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

Regency IHS of Fairwinds Halletsville, LLC

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.