H&E Equipment Services

An employee had been watching contractors unload equipment. The employee slipped on gravel and struck their head on a truck's bumper. The employee was hospitalized and received stitches.

An employee was troubleshooting a mobile power unit compressor when his hand entered the running machine, breaking two fingers.

An employee was stepping down from the tailgate of a customer's pickup truck. The truck then backed up and struck the employee, then pulled forward, striking them again while they were underneath the truck. The employee sustained fractures to their L3 vertebra, ribs, and a leg.

An employee was in front of a skid loader that was hauling a tree to be planted. The employee was holding the tree so it wouldn't fall over when his leg and foot were run over by the skid loader and fractured.

An employee was walking through the parking lot, returning from their break, when a motor vehicle struck them. The employee sustained a concussion, facial fracture, and contusions.

An employee was walking up to a powered industrial vehicle (PIV) to grab a water bottle. As the vehicle was turning, the employee was struck by the PIV and sustained a spleen laceration and injury to the left arm and chest. The employee was hospitalized.

While standing on the curb in front of the store, an employee was struck by a car. The car was then put in reverse and ran over the employee again. The employee sustained fractures to their ribs and both legs.

An employee was pulling a data cable through a ceiling. He fell through the ceiling, landing at ground level. He suffered a laceration to the forehead, a dislocated left little finger, a broken left ring finger, and a laceration to the liver.

On September 16, 2025, an employee was installing and adjusting spotlights on a performance stage that was under construction. While crossing the stage to speak with other contractors, the employee encountered a section of the stage where the elevation changed to a lower level. As the employee stepped down 14 inches to the lower level, his knee locked up and he fell to the stage. He subsequently rolled off the stage and fell approximately 2 to 3 feet to the floor, resulting in a fractured tibial plateau in his right leg.

An employee was delivering a 65-foot boom lift to a rental customer's construction site. The employee set up the ramp truck in the parking lot adjacent to the construction site. He elevated the boom 4-5 feet to clear a temporary fence. While driving the boom lift off the ramp, the wheels slid to the driver's side of the ramp truck, ultimately sliding off the ramp. The boom lift fell off the side of the truck and rolled onto its side. The employee sustained a fractured clavicle, a dislocated shoulder, separated/fractured ribs, a punctured lung, and a fractured left femur. The employee required surgery.

An employee was performing maintenance on a telehandler and installing a carriage lift cylinder. The employee was checking the alignment when the cylinder slipped and partially amputated his left middle finger.

An employee had just serviced a battery and was reinstalling it in a forklift using a battery extractor. The employee was trying to pull the battery out of the battery compartment when the extractor moved, causing the battery to shift on the rollers. The employee's right hand was crushed between the top of the battery and the battery compartment.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.