Caught in running equipment or machinery, n.e.c. · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Sanderson Farms, Inc. - Laurel Processing, 2535 Sanderson Drive, LAUREL, MISSISSIPPI 39440
on — Crushing injuries, affecting the hand(s), unspecified.
Final narrative
An employee had been inspecting a leg processor machine. While adjusting a water sprayer hose on the machine, their right hand was caught and crushed in a moving gripper chain.
An employee stabbed the injured employee with a knife in the breakroom during an altercation. The injured employee sustained stab wounds to their chest and abdomen.
An employee was leaving a room when the door closed and their glove was caught in the door hinge. The employee's right little finger was partially amputated.
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 311615)
An employee was unloading a forklift from a trailer to the ground. The employee was climbing down the ladder of the trailer when their foot slipped through one of the rungs, causing them to fall backward onto the forklift forks. The employee was hospitalized for fractured ribs.
An employee was troubleshooting a thigh deboner on a poultry processing line. As he worked to dislodge a thigh bone caught in the blade mechanism, the machine amputated the first and second digits on his left hand. He was hospitalized.
On September 25, 2025, an employee was exiting a yard truck. They slipped and fell approximately 3 feet from the top tread of the steps to the concrete below. The employee sustained a fractured left hip.
An employee was operating a stand-up forklift, picking product for an order. The forklift struck a metal rack and the employee's left arm was caught between the forklift and the rack. He was hospitalized with a fracture to the neck of his radius and an open fracture to the olecranon (elbow).
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.