Caught in running equipment or machinery during regular operation · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at U. S. Dept. of Defense, Fort Bragg South Commissary, FORT BRAGG, NORTH CAROLINA 28310
on — Cuts, lacerations, affecting the hand(s), unspecified.
Final narrative
An employee was using a meat grinder to tenderize round steaks when her gloved left hand became caught in the blades. The employee sustained lacerations and torn tendons.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 928110)
An employee was activating the sprinkler system at a sports complex following recent maintenance to repair leaky pumps. When the system was activated, a section of newly installed 3-inch schedule 80 PVC pipe struck the employee, who lost consciousness. The employee suffered a broken jaw and a concussion.
An employee was ascending a flight of stairs after exiting their vehicle in an adjacent employee parking lot. The employee stepped to the right to avoid another employee on the left who was descending the stairs. The employee lost their balance and fell on the stairs. They were hospitalized with a laceration/abrasion to their chin, a fractured left humerus, and bruising to their left knee.
At about 3:10 p.m. on October 3, 2025, an employee was inspecting a car. Two dogs that had been in another car were leashed and tethered to a bollard. As the employee inspected the first car along with a narcotics detection dog, one of the other dogs came loose and attacked the narcotics dog. The employee was separating the dogs when the other dog bit his left ring finger. The last joint of the finger was injured and part of it was bitten off.
An employee was climbing a fixed ladder to perform maintenance in an attic. While unlocking the attic entry, the employee fell from the ladder more than 10 feet to the concrete below. The employee suffered a fractured hip, pelvis, tail bone, arm, and elbow, resulting in hospitalization and surgery.
An employee was attaching a steel angle plate weighing (approximately 200 pounds) to the end of a structural member (5,000 pounds) and was supported by dunnage. The dunnage was a crane mat (11 inches tall) with a 4x6 board on top of it and it supported five identical members. The main piece was 30.75 feet long, 37.25 feet tall, and 1 food wide. As the employee slid the piece of metal on top of the member to begin attaching it, the entire member began to tip over. The employee went to stop the main piece from tipping over and it landed on his ankle, fracturing it.
An employee was preparing hot melted butter on a flat-top grill and placing it in small containers once it was melted. As she turned to set the container down, it slipped out of her hand and landed on the grill. Butter splashed up and hit her in the face. The employee suffered second-degree burns to her right eye and the right side of her head and face, as well as first-degree burns to her right forearm.
An employee pulled into the customer's driveway, parked, and exited the vehicle. He opened the sliding side door on the vehicle to retrieve a package. The customer began backing their vehicle out of their garage and it struck the employee in the back of his left leg. He was pinned him between the two vehicles, causing contusions and lacerations.