ENTERGY Grand Gulf

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

An employee was using a chain fall to install a liner in a mill. As he was setting the liner in place, his right index finger got stuck in a chain on the rigging, resulting in a fingertip amputation that required hospitalization and a surgical reattachment.

An employee was descending a fixed 15-foot ladder. The employee slipped and fell, landing on a snubber machine 8 feet below and suffering a laceration to the left thigh and a fracture to the sternum.

An employee was walking to leave the worksite, slipped on mud, and fell to the ground. The employee suffered a C5 vertebra fracture that required surgery.

An employee was lowering himself on a scissor lift after inspecting a chain hoist. An auxiliary hoist being installed on the manipulator crane fell approximately 8 feet from its installed location and struck the employee in the upper back, fracturing two vertebrae.

An employee was assembling a pump with their left little finger positioned between the impeller and the discharge spacer. The element contacted the pump case's seating position and the shaft continued to move, pinching their fingertip between the two components. The employee sustained a fingertip amputation through part of the nail. The incident occurred during training.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.