Occidental Petroleum Corporation

An employee was depressurizing an isolated section of piping in preparation to service a CO2 injection well meter. The 1/2-inch meter assembly piping parted and struck the employee, fracturing their right humerus.

An employee was bleeding down injection lines, using a 36-inch pipe wrench, to let hydrates thaw overnight. A valve was opened and pressure (about 900 psi) was released, causing a section of pipe to come loose and strike the employee's leg above the knee. He was hospitalized.

An employee was emptying and cleaning a trash container when he noticed a bite on his ribcage. The employee was hospitalized for a poisonous spider bite.

An employee was bitten by a copperhead snake while loading firewood.

An employee was working an investigation. He pulled a trash can from a suspect s house and was bitten by fire ants. On the way back to the office the employee developed hives and went into anaphylactic shock. The employee was hospitalized.

An employee was stung multiple times by bees while they were in a field. He suffered a severe allergic reaction and was hospitalized.

An employee was picking up brush and debris for storm restorations when their left index finger was bitten by a copperhead snake.

An employee had been cleaning the work area. While lifting a saw, the employee's index finger was lacerated by the saw blade. A tendon was cut and required surgery.

An employee was delivering home heating fuel when bees came from the ground and stung the employee's face, neck, torso, and hands. The employee proceeded to shut off the oil flow before losing consciousness. They were hospitalized due to an anaphylactic reaction.

An employee was using a torch to loosen a bolt on a water trailer. Natural gas was present in the water and it ignited, causing a fire. The employee sustained third-degree burns to their upper leg.

An employee had been conducting crane operations. The employee went to stop a piece of oil and gas equipment for tubular running from falling over to the ground. Their right hand was caught between a rolling ladder and the equipment, resulting in fractures to the index and middle fingers. They were hospitalized and the middle finger required surgery.

An employee was working to install a drive belt on a water pump. He was holding the belt on both sides of the pulley, working to route it over the top. As he pulled down with his right hand, the pulley rotated and the belt slid over it, pulling his left little finger between the pulley and the belt. He suffered an amputation to the fingertip as well as a fracture to the ring finger.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.