Y-W Electric

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

Employees were preparing to replace a primary electrical cable. While two of the employees were working to remove the cable on one side of a switchgear, they came into contact with a wrench and the outside part of the switchgear. One employee suffered an electrical shock.

An employee was walking to her work truck when she tripped over a safety cone and fell to the asphalt, resulting in a fractured tibia.

An employee was installing personal protective grounds at a substation when their hand contacted the end of the ground that was not energized, but induced voltage was created by wind and shocked them. This resulted in a burn on their thumb.

At about 9:35 a.m. on March 18, 2024, an employee was conducting maintenance on a non-operational fan controller in a switchgear room. The employee pulled the controller and began installing a new one. The employee was electrocuted, suffering third-degree burns to the right hand and fingers as well as burns to the right forearm, and was hospitalized.

An employee was working outside, sustained a heat-related illness, and was hospitalized.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.