Direct exposure to electricity, greater than 220 volts · Second degree electrical burns
At a glance
Federal OSHA recorded a severe workplace injury
at Blue Bird Corporation, 402 Blue Bird Blvd., FORT VALLEY, GEORGIA 31030
on — Second degree electrical burns, affecting the multiple body parts, n.e.c..
Final narrative
An employee was working in a scissor lift, replacing the ground wire in an electrical box. The employee came into contact with the live wire and an arc flash shocked the employee with 480 volts, causing first- and second-degree burns to the employee's face and arms.
HospitalizedMultiple body parts, n.e.c.Switchboards, switches, fuses
The injured employee was installing fan belts and alternators. Another employee came into the work area with a torque gun and began poking the injured employee with the tip of the torque gun and then activated the tool. The spinning tip of the torque gun caught the injured employee's left glove and amputated her middle finger.
An employee was operating a lathe machine to sand a bolt. The emery paper became caught on the bolt, pulling his right hand into the bolt and twisting his thumb. His right thumb was surgically amputated.
An employee was cutting conduit with a portable electric saw. The tool bounced and the blade reached the employee's left hand, amputating part of the last joint on the index finger.
An employee was coming out of a bus and saw something laying on the ground. He was stepping to the side to miss the object when he fell and twisted his ankle, fracturing it and requiring hospitalization.
An employee was installing a ground wire to a power transmission pole. The ground wire contacted an energized portion of a cut-out, causing an arc-flash. The employee was hospitalized with second degree burns to their chest and arms.
An employee was connecting a utility transformer for underground service to a home. The employee's impact drill went across two connection bars with 240 volts of potential, creating an arc flash. The employee sustained burns to the face and eyes due to the arc flash and molten aluminum.
On December 15, 2023, at 9:15 AM, an employee was changing 60-amp fuses in a 480-volt panel when an arc flash occurred. The employee was hospitalized with burns to both hands.
An employee was walking on a dock plate to open the door for the next trailer. He tripped on a cargo strap that was laying on the dock and fell. The employee sustained a fractured right hip, requiring hospitalization and surgery.
On September 18, 2025, an employee was rolling a stack of two steel racks containing automobile bumpers when the top rack dropped, pinching their right little finger. The employee suffered a partial amputation.
An employee was exiting an ambulance when his foot slipped, causing him to hit either the portable aluminum step or the concrete floor. He suffered a broken left elbow.
Two employees were sliding a 200-pound steel mounting plate off a worktable onto the forks of a forklift. They slid the plate until it was half on the table and half on the forklift, and were making an adjustment to get the plate fully on the forklift when the plate pinched one employee's left ring finger. He suffered a partial amputation to the fingertip.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.