105,313Records 71,083Employers 85,290Hospitalizations 27,770Amputations 2015-01-01 2025-10-31
Safety Incidents OSHA Severe Injury Reports · 2015–2025

Pennsylvania Transformer Technology, Inc.

Other fall to lower level less than 6 feet · Fractures

Federal OSHA recorded a severe workplace injury at Pennsylvania Transformer Technology, Inc., 30 Curry Avenue, CANONSBURG, PENNSYLVANIA 15317 on — Fractures, affecting the ankle(s).

An employee was working from the top platform of a portable stair tower. While reaching in the direction of the stairs, the employee fell approximately 5 feet to the ground below and sustained a broken ankle.

Hospitalized Ankle(s) Stairs, steps, unspecified

Pennsylvania Transformer Technology, Inc.

An employee was moving a steel coil that was 4.5" in width and weighed 1,340 lbs. from where it was being stored to the machine using an overhead crane. As the employee was attempting to roll the steel coil out from where it was stored to attach it to the crane, it started to become off balance and tipped over, landing on the employee's legs. The employee was trapped under the steel coil and sustained a broken tibia and fibula that required surgery.

Pennsylvania Transformer Technology, Inc.

An employee was operating a drill press when his sleeve became wrapped around the bit, fracturing his arm in two places and requiring surgery.

View Pennsylvania Transformer Technology, Inc.'s full OSHA safety record →

Electrical Contractors Inc.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

M1 Support Services

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

FEDEX Ground Package System, Inc.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

SRM Concrete

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

U.S. Postal Service - Los Angeles P&DC

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

Howard Industries Inc.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

Howard Industries Inc.

An employee was troubleshooting a machine. He was investigating a slipping belt when it caught his left hand and pulled it into a pulley, partially amputating the tip of his thumb.

Howard Industries, Inc.

An employee was tilting a radiator in a fixture. The radiator moved in the fixture and crushed the employee's left index fingertip, causing an amputation.

Sunbelt Solomon Services, LLC

An employee installed a busbar on a coil for a winding machine. The busbar hit a tension bar, causing his left ring finger to get caught between the coil and the tension bar, which pulled in the employee's glove and resulted in a medical fingertip amputation. The machine was guarded at the time.

WEG Transformers USA

An employee was operating a wire winding machine when their clothing was caught in a rotating component, pulling them into the equipment. The employee's right arm was fractured.

Main Line Clinical Labs

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

Ardent Mills

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

Zimmerman & Herr

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

McAneny Brothers, Inc.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

Metz Culinary Management LLC

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.