Fall on same level due to tripping, unspecified · Chemical burns and corrosions, unspecified
At a glance
Federal OSHA recorded a severe workplace injury
at Hilite International , 1671 S. Broadway St. , CARROLLTON, TEXAS 75006
on — Chemical burns and corrosions, unspecified, affecting the multiple body parts, n.e.c..
Watch Hilite International — freeGet an email when a new federal OSHA severe-injury report for Hilite International is published. One employer, no account, unsubscribe in one click.
Final narrative
An employee went to the wastewater area to get additional sulfuric acid for the anodizing process. While walking back to the anodizing area with a bucket of sulfuric acid, she tripped and fell. The sulfuric acid splashed on her, causing chemical burns to the wrist, neck, and legs.
HospitalizedMultiple body parts, n.e.c.Floors, walkways, ground surfaces, unspecified
An employee was walking down the hall to retrieve a vacuum when they stumbled and fell to the floor. The employee suffered wrist bruises and a kneecap fracture that required surgery.
An employee was installing a compressor piston. He tripped and fell backward while the piston was in his lap. As he landed, the little finger of his left hand became caught between the piston and compressor piping resulting in a partial amputation of the fingertip. The employee required stitches and the fingertip was reattached.
An employee was doing an oil change. He was walking to get his oil jug when he tripped on an open lift pad, and fell to the ground landing on his right side. The employee sustained a broken right femur and was hospitalized.
More severe injuries in this industry (NAICS 336310)
An employee was pushing automotive suspension material using a material rack. The material started to shift and caught the employee's right little finger, crushing it. The employee suffered an amputation to the finger. The finger was re-attached.
An employee was assembling the gearbox of a lower unit (of a boat motor). They used a handheld electric drill to power the lower unit's gears and inspect the assembly. A gear was out of tolerance, so the employee placed sandpaper in the gearbox to remove any burrs or other material. The employee activated the drill and their left middle finger contacted a nip point between the gears in the unit, resulting in a fingertip amputation.
An employee was reaching for a label and stepped onto a metal piece along rollers and slipped. His leg went down into a gap between the machines and contacted the metal in the gap between the rollers. The employee was hospitalized with the avulsion of skin on his left shin between the ankle and knee, as well as injuries to muscle and ligament.
On June 10, 2025, an employee was driving a forklift west when they were struck by another forklift driving south. The suffered a puncture wound on the right calf.
An employee had just moved a large coil of steel next to another coil on a rack using an overhead crane. They unhooked one side of the sling and held onto it with their right middle finger. As they were raising the crane back up, the sling hung up under the coil, building tension; once it released, it quickly jerked the other side of the sling through the coils along with the last joint of the employee's right middle finger. The finger was amputated to that joint.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.