Struck by suspended or swinging objects n.e.c. · Amputations involving bone loss
At a glance
Federal OSHA recorded a severe workplace injury
at Nakanishi Manufacturing Corporation, 1225 Voyles Road, WINTERVILLE, GEORGIA 30683
on — Amputations involving bone loss, affecting the Finger or thumb tip(s), nail(s).
Final narrative
An employee had just moved a large coil of steel next to another coil on a rack using an overhead crane. They unhooked one side of the sling and held onto it with their right middle finger. As they were raising the crane back up, the sling hung up under the coil, building tension; once it released, it quickly jerked the other side of the sling through the coils along with the last joint of the employee's right middle finger. The finger was amputated to that joint.
HospitalizedAmputation Finger or thumb tip(s), nail(s) Reels, rolls, spools, coils
More severe injuries at Nakanishi Manufacturing Corporation
An employee was placing a steel coil that weighed approximately 5000 lbs. back into the coil rack when the banding caught on another coil, causing it to twist and strike the employee in the chest. The employee suffered a bruised liver, bruised kidneys, and internal bleeding.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.
An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.
An employee was placing a board on top of a bundle of steel tubing. A crane was moving a bundle of steel that struck the employee and caught them against another bundle of steel tubing. The employee sustained a crushing injury and hematoma to the right upper leg.
Employees were using a crane to lower large tree stems and branches while removing limbs and branches from the load. This caused the load to shift and strike an employee in the back, resulting in a hematoma on the lower left part of their back and a fractured ankle.
More severe injuries in this industry (NAICS 336310)
An employee was pushing automotive suspension material using a material rack. The material started to shift and caught the employee's right little finger, crushing it. The employee suffered an amputation to the finger. The finger was re-attached.
An employee was assembling the gearbox of a lower unit (of a boat motor). They used a handheld electric drill to power the lower unit's gears and inspect the assembly. A gear was out of tolerance, so the employee placed sandpaper in the gearbox to remove any burrs or other material. The employee activated the drill and their left middle finger contacted a nip point between the gears in the unit, resulting in a fingertip amputation.
An employee was reaching for a label and stepped onto a metal piece along rollers and slipped. His leg went down into a gap between the machines and contacted the metal in the gap between the rollers. The employee was hospitalized with the avulsion of skin on his left shin between the ankle and knee, as well as injuries to muscle and ligament.
On June 10, 2025, an employee was driving a forklift west when they were struck by another forklift driving south. The suffered a puncture wound on the right calf.
A maintenance technician was cleaning a piece of equipment that is used to pump grease when their hand became caught between a pulley and belt on the equipment. The employee sustained a right middle fingertip amputation.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.