KONZ WOOD PRODUCTS INC

On September 25, 2023, employees were flipping over a particle board that measured 5 feet by 8 feet. The particle board fell onto the injured employee's hand, resulting in a fingertip amputation.

An employee was operating a table saw with a dado blade. While he was leaning down in a crouching position, he pulled back and his finger contacted the blade, amputating his fourth fingertip with bone loss and a fracture.

An employee was operating a machine when a wire pulled his right glove resulting in amputation of the index and middle fingertips.

An employee was grinding chicken when their right index fingertip was caught in the grinder and amputated.

An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.

An employee was passing through a large metal door when the door closed on the employee, resulting in a cracked rib.

An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.

An employee was walking down the off ramp from a box truck, carrying a door for delivery. A strong wind caught the door, causing the employee to lose balance and fall about 2 to 3 feet to the ground. He landed on his back and suffered a broken vertebra.

An employee was loading lumber from a rack into his truck by hand. He fell from the truck to the ground and sustained a fractured hip.

An employee was delivering lumber to a customer's job site. He was using a truck-mounted forklift to transport the material to the staging area. The surface of the path of travel changed from asphalt to soil and rock with a slight downward grade. When the forklift moved onto the softer surface, it sank into the ground and its center of gravity shifted forward, causing it to tip over. The employee's right arm sustained a closed, supracondylar humerus fracture.

An employee was helping two forklift operators move and inventory flat sheet metal that was staged on racks. The metal fell off one side and struck the employee's arms and abdomen. The employee sustained a laceration above the left eye, a left forearm injury, and a ruptured spleen. The employee was hospitalized and required surgery.

An employee was cleaning a press machine when their right ring finger became caught in the press, resulting in the amputation of the finger.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was using a vertical band saw to cut a thick piece of rubber material. While being cut, the material shifted, causing the employee s right hand to contact the moving blade. The employee's thumb was amputated below the knuckle. The employee was hospitalized, undergoing surgery.

A production sanitation employee was pre-rinsing an incline conveyor and noticed cheese stuck between the belt idler. The employee went to remove the cheese and their glove got caught and pulled their left forearm into the conveyor. The employee's arm was fractured. The machine was not locked out/tagged out at the time.

An employee was on a ladder, taking measurements for a new gutter installation. The ladder slipped out from under him and both he and the ladder fell to the ground. He was hospitalized with seven broken ribs and a broken clavicle.

An employee was unloading a truck for a delivery job. While moving boxes in the truck, the employee tripped over a pallet and fell out of the truck to the ground, resulting in four broken ribs.