Fiber Materials, Inc.

An employee was on a double-end rider in an aisle selecting product when his left leg was pinned between the rack and rider.

An employee was using a forklift to load a tractor trailer when the forklift skidded into a wall. The employee sustained an arm fracture.

An employee was training on an rolling container carrier on the dry, non-frozen storage side of the distribution center. She made a turn around the end cap and her right foot struck the rail protecting the endcap racking. The employee's foot was fractured.

An employee was a passenger in a utility vehicle that was driving up a hill on a wooded trail. As the vehicle made a right turn, three fingers on the employee's right hand were caught against a tree and fractured.

An employee was operating a forklift when his left leg was caught between the forklift and a bollard resulting in a broken leg.

Two employees were setting up a mandrel in the spindle of a machine. The mandrel was side-shifted while an employee's hand was on the mast of a powered industrial truck. The employee suffered crushing injuries that resulted in amputations to the middle and ring fingertips.

An employee was loading an air surveillance plane turret into a shipping container using an engine hoist. The lifting chain detached from the hook and the spreader bar struck the employee in the face, resulting in an eye injury that required hospitalization and surgery.

An employee was trying to remove a chip tray from the bottom of a drilling machine. The machine injured the top of the employee's right hand and the tips of four fingers.

An employee was setting up a lathe. As he turned the chuck with a chuck key, his left little finger was caught between the key and the operator panel. The fingertip was amputated to the nailbed.

An employee sustained a partial amputation of the left thumb while operating a hydraulic crimper.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.