Injured by slipping or swinging object held by injured worker · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Cellofoam North America, Inc., 1961 Rockdale Industrial Blvd. , CONYERS, GEORGIA 30012
on — Amputations, affecting the fingertip(s).
Final narrative
An employee was sanding a piece of metal with a disk sander when the clamps holding the piece of metal did not fully engage due to a build-up of debris. The disk sander then amputated the employee's right thumb tip with bone loss.
AmputationFingertip(s)Sanders-powered
More severe injuries at Cellofoam North America, Inc.
An employee was driving a forklift in an outside yard. The forklift became stuck on the gravel and dirt and had to be towed with a cable attached to the top of its roll cage. It flipped, and the employee's leg was caught between the engine cover and the left side of the truck. He suffered a broken tibia and fibula.
The injured employee was using a blower to clean the floor when a 192" tall block of expandable polystyrene (EPS) foam weighing 200 lbs. turned over and struck the employee as he walked by it. EPS foam blocks are moved from the block mold to the production floor by an operator using a tip method. The injured employee suffered a vertebra fracture.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 326140)
An employee was performing a maintenance task on a shape mold machine. The equipment had a clog preventing it from pumping material into the next stage. The employee's left hand was inside the hopper's butterfly valve when it unexpectedly turned. The employee's index and middle fingertips were partially amputated.
An employee was stacking used cardboard onto a pallet in the shipping and receiving area when he tripped over the scale by the loading dock door. The employee fell to the concrete floor and was hospitalized with a fractured left hip that required surgery.
On May 14, 2025, an employee was manually adjusting a plastic sheet entering the thermoforming oven when their right hand was pulled into the pin chain and idler wheel. The employee sustained the amputation of their middle finger.
At 6:30 p.m. on April 23, 2025, an employee was using a CNC panel saw when his fingers were pinned in by the pressure beam used to hold the board he was cutting. The sawblade, coming from beneath, amputated about 1/4 inch of his right little fingertip.
An employee was diagnosing an issue with a bagger that had jammed. The employee was cleaning out a piece of supporting equipment (a scrap barrel) when the blower motor contacted his right middle fingertip and fingernail, resulting in an amputation. The blower motor was not guarded at the time.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.