Pedestrian struck by vehicle in nonroadway area, n.e.c. · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Larry Fisher & Sons, 2450 Midpoint Drive, EDWARDSVILLE, KANSAS 66113
on — Fractures, affecting the multiple trunk locations.
Final narrative
An employee was assembling warehouse storage racks/shelving when a PIT struck and knocked over three 4-foot-wide by 30-foot-long upright racks that were laying parallel to the floor in the staging area. The uprights struck the employee, who suffered a fractured hip and three fractures in his back. He was hospitalized.
HospitalizedMultiple trunk locationsForklift, order picker, platform truck-powered
An employee was stepping down from the tailgate of a customer's pickup truck. The truck then backed up and struck the employee, then pulled forward, striking them again while they were underneath the truck. The employee sustained fractures to their L3 vertebra, ribs, and a leg.
An employee was in front of a skid loader that was hauling a tree to be planted. The employee was holding the tree so it wouldn't fall over when his leg and foot were run over by the skid loader and fractured.
An employee was walking through the parking lot, returning from their break, when a motor vehicle struck them. The employee sustained a concussion, facial fracture, and contusions.
An employee was walking up to a powered industrial vehicle (PIV) to grab a water bottle. As the vehicle was turning, the employee was struck by the PIV and sustained a spleen laceration and injury to the left arm and chest. The employee was hospitalized.
While standing on the curb in front of the store, an employee was struck by a car. The car was then put in reverse and ran over the employee again. The employee sustained fractures to their ribs and both legs.
More severe injuries in this industry (NAICS 337215)
On August 13, 2025, an employee was feeding wire through a junction box to feed a 120-volt circuit near a 480-volt bus duct. The bus duct suddenly combusted, and the employee suffered burns to his left hand and upper body. He was hospitalized.
An employee was operating a brake press and making the final bend on a steel part. Her right middle finger got caught between the part and the top punch as it bent the part upward. The employee sustained a crush injury resulting in amputation of the fingertip.
An employee was feeding scrap metal into a chipper when his right hand was squeezed against a metal component of the machine. He suffered an amputation to the right index finger at the second joint.
On June 18, 2025, an employee working as a millwork installer was cutting shims using a circular saw. The saw hit a knot in the wood and jumped, cutting the palm of the employee's left hand and causing partial amputations to three fingers. The employee was hospitalized.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.