Barnhart Crane and Rigging

An employee was on a manlift approximately 5 feet above the ground while adjusting the rigging on a 12-foot granite column weighing approximately 12,000 pounds. The rigging failed and the column struck the manlift, causing a crush injury to the employee's leg.

After he had changed a block and adjusted the wire rope in the sheave, an employee's right hand was pulled between the wire rope and the block. His hand was amputated and required hospitalization.

An employee was loading a dish washing machine. A plate bumped against the machine and broke, lacerating the employee's left arm. The employee was hospitalized and required surgery.

An employee was throwing a mirror into a dumpster when the mirror shattered and lacerated the employee's arm.

Two Rycon employees were installing glass marker boards in a nearly completed space. Each employee had a suction cup on the face of the board and a hand on the bottom of the board. Upon hanging the third board in sequence on a hang strip mounted to the wall, the board needed to be moved about half an inch to butt tightly to the adjacent one. When the employees moved the marker board, it shattered causing half of the board to fall and cause a severe laceration to an employee's left wrist.

On May 15, 2023, an employee removed a mirror from the bathroom to discard it. As the employee went to place it on the cart, the mirror broke. The employee sustained a laceration on the right forearm that required surgery.

An employee was lifting a round, glass table top while working on a waste collection route. The glass table top shattered and lacerated the employee's arm.

A crew was relocating a dumpster (containing approximately 200 pounds of demolished wire) to access the uninterruptible power supply (UPS) units they were servicing. During movement of the dumpster, a section of carpet tile dislodged from the floor, causing an employee to lose his footing, slip, and fall. He landed on his right wrist, resulting in a fracture.

An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.

An employee was using an aluminum extension ladder to remove gutters at a height of approximately 20 feet. As they were removing the gutters, part of the gutter collapsed and struck the ladder, causing it to move sideways. The employee fell from the ladder and sustained fractures to ribs on the left side and their right forearm.

An employee was using an electric saw to cut a piece of wood for a fence. The saw slipped out of his hand and lacerated his left leg. He was hospitalized.

An employee was erecting a scaffold. A side bracket was not secure. The employee stepped on the bracket to test it and fell 18 feet to the concrete floor resulting in fractures to the ankles and femurs. He was not using fall protection equipment.

An employee was stacking concrete blocks for a concrete bunker. As a block was swinging into place, the employee's left leg was pinched between two blocks, resulting in injuries to his left heel and lower leg.

An employee was climbing a ladder to inspect a vent in a restaurant dining area. The ladder slid out on the floor and the employee fell approximately 12 feet onto the ladder and the floor. He was hospitalized with a dislocated shoulder and a back injury.

An employee was rappelling down a tree. When he was most of the way down, he fell on the ground and suffered a broken pelvis.

An employee was filtering a fryer with a fryer filter machine. After going around the corner and then returning to the fryers, the employee stepped into the filter machine. The hot oil burned the employee's right ankle, and the employee was hospitalized.

An employee was cleaning out corn from a grain bin. The sweep auger in the bin was activated and caught his trouser leg. His leg was pulled into the auger, which injured his calf and caused leg fractures and lacerations.