Jan-Eze Plating, INC

An employee was assisting with pipe on a drilling rig. The slips came down and landed on the employee's left foot fracturing four metatarsals.

Two employees were struck by the rotary table of a drilling rig while installing caisson. Employee 1 suffered multiple fractures, internal injuries, and head trauma. Employee 2 suffered multiple fractures, internal injuries, spinal injury, and head trauma.

Employees were felling hazard trees. The injured employee was conducting 'bucking' operations to saw a tree from the road when the tree kicked-back, pinning him against the ground and fracturing his left femur. The employee was hospitalized and required surgery.

An employee was greasing tongs on a work-over rig. The tongs lacerated one of the employee's fingers.

An employee was chaining a vehicle when he had to change tools and the compressor. As the compressor was being charged, the employee stepped near the vehicle to make sure the compressor was attached. Then, he instructed a co-worker to lower the compressor. His right hand was on the compressor and under the chain, causing his ring finger to be crushed.

An employee placed an aluminum step ladder beside a tractor trailer and was removing a piece of scrap aluminum from the trailer that resulted from a motor vehicle accident. While coming down the ladder, the employee fell approximately 6 feet to the concrete. The employee was hospitalized with a fractured T4 vertebra.

On August 26, 2025, an employee was repairing a pipe at a tank. The employee fell and slid down the tank, suffering severe lacerations to the lower arms. The employee was hospitalized.

On August 26, 2025, a temporary employee was assisting a mechanic. The employee was on an overhead crane, removing a chain hoist attachment over a large plating tank. When the platform of the crane was moved, the employee became caught between the platform's railing and a support beam. The employee sustained a punctured lung and fractures to their clavicles, humerus, and ribs.

An employee was adding an all purpose soak and electro cleaner chemical to a water tank to make a cleaner bath. An exothermic reaction caused the 200 F water to splash on him, and he suffered hot water and steam burns to the right side of his face, his upper right arm, the right side of his torso, and his right leg.

At 3:00 AM, on 2/18/2025, an employee was mixing chemicals. The employee had difficulty breathing due to inhalation of unknown chemicals. The employee was hospitalized.

An employee was operating an ironworker (steel punching/shearing) machine. A piece of the tooling broke off and struck the employee's neck; a fragment was lodged in his neck. The employee was hospitalized and required surgery.

On October 25, 2025, an employee was stringing up a new reel of tire tread on a machine. The employee pulled a 6-inch tail and proceeded to spool up the liner. As the machine was jogged to begin the liner wrapping process, the liner caught the employee's glove and pulled their right arm into the liner, causing a fracture to the arm.

An employee was doing a cable change on top of an electric overhead traveling (EOT) crane. They were positioned between the cable drum and the drive shaft. While rotating the cable drum, the employee reached for the new cable that was to be installed. The grease fitting on the drive shaft caught their fall harness and pulled them underneath the drive shaft. The employee was pinned between the drive shaft and two pieces of angle steel, resulting in a fracture to their left hip.

An employee was helping two other employees to push a pallet of tile on a loading dock. He suffered a broken fibula and was hospitalized.

On October 5, 2025, an employee was pulling a pressure washer hose when it it disconnected from the cooker. The employee was struck by jets of high-pressure water, resulting in lacerations to their left thigh requiring surgery. The employee was hospitalized.