Select Building Group

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

Employees were at the trucks to leave for lunch. The injured employee was putting the cone back after the crew leader pulled the truck forward from the designated worker parking area. The injured employee then ran back to the truck. As he went to get in the truck, he said the upper thigh area of his leg was hurting. He laid on the ground outside the truck and crew leader could see a bump/bulge in the the injured employee's upper thigh area below his hip. The employee sustained a fractured femur and required surgery.

An employee was helping a contractor unload a delivery of two new dock plates from a trailer onto a forklift. The employee s left index and middle fingers were pinched by the dock plates, resulting in amputations to both fingers above the first joint.

An employee was helping to load a customer's truck. The employee stepped toward a forklift to get paperwork from the driver. The employee's right lower leg and foot were run over by the back tire of the forklift. The employee was hospitalized with fractures to his lower right leg.

An employee was moving wet bundles of shingles on a truck bed, when one of the bundles slipped out of his hands. He tripped over a pallet, fell off the bed of the truck, and landed on his left side. The employee sustained fractures to three ribs, and a displaced iliac fracture.

On August 12, 2025, an employee was loading shingles onto the roof of a new-construction home when be began to suffer from heat exhaustion and dehydration.

An employee was delivering materials. He was doing his pre-delivery inspection on the roof of the jobsite (a warehouse) when he fell through a plexiglass skylight. He landed on his feet on the concrete floor 14 feet below. The employee sustained fractures to his spine, left ulnar/radius, and right heel. The employee required surgery.

An employee was cutting cabinet trim using a table saw when four fingers on his left hand were severed, resulting in hospitalization and amputation.

An employee was removing packaging from a roll of printing substrate. The blade of their utility knife got stuck. The employee used both hands to free the knife and the blade partially amputated their left little fingertip.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.