Machinery or equipment incident on water vehicle · Cuts and abrasions or bruises
At a glance
Federal OSHA recorded a severe workplace injury
at Orion Construction, LP, Exxon Mobile Ship Dock 5, BAYTOWN, TEXAS 77520
on — Cuts and abrasions or bruises, affecting the multiple head locations.
Final narrative
An employee was pulling a pin from a stud in preparation for mooring operations. The pin struck the employee, causing contusions and a laceration on the right side of the face and a hematoma on the back of the head.
HospitalizedMultiple head locationsWater vehicle, unspecified
Employees were unloading logs on a logging vessel. The injured employee was standing on the deck as a load came in. The sling popped off the load and the end of the choker struck the employee's lower left leg, resulting in a shin fracture.
An employee was exiting a confined space while carrying a pressure gun when the trigger activated. Water penetrated the employee's left arm, resulting in injury.
The employee was putting shackles on the grab of a vessel-operated crane. As the crane was lifting the grab, it started to swing toward the hopper. The employee reached to stop it when they were caught and lifted by the grab and pinned between it and the hopper. The employee sustained a pelvic fracture and lacerations to the arm and pelvis.
An employee was launching a boat during rough sea conditions. The employee lost balance, causing their left index and middle fingertips to be caught in the eye of the bow line, resulting in amputation.
Two employees were in a boat pulling a 45-pound anchor out of the water by the rope. The rope tightened and as the employees were attempting to create slack in the rope, the injured employee began to slip. His hand was caught between the rope and the inside of the platform boat, resulting in amputation of the right middle finger with bone loss.
More severe injuries in this industry (NAICS 237990)
A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.
An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.
Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.
A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.
An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.