S&B Engineers and Constructors, LTD

An employee was walking on level, grassy ground when he suffered a broken left knee at the distal end of the femur. He was hospitalized and required surgery.

An employee was disconnecting an air hose when it whipped around and struck the employee in the lower leg. The leg was broken.

Employees were moving a large electrical cabinet when it tipped over, striking an employee. The injured employee sustained a fracture and ligament damage requiring hospitalization and surgery.

An employee was caught between a counter weight and the crane outrigger when the outrigger slipped during crane assembly. The employee sustained approximately 4-5 fractured ribs and a fractured T12 vertebra.

An employee was walking on a level hallway surface inside an office building when she collided with another employee and fell to the floor on her hip area. She fractured her hip and was hospitalized.

An employee was stepping from a bus onto the curb when they sustained a right strained hamstring.

An employee was walking on steps when they slipped and twisted their ankle, resulting in a fracture.

An employee was stepping from a parking block down into a parking spot when he twisted his right ankle, resulting in a fracture.

An employee was stepping down from a work platform to the ground when they rolled their left ankle and fractured it.

An employee was operating a forklift in the warehouse. As they were dismounting, the employee felt pain in their leg from stepping down and sustained a left leg fracture.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.

An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.

An employee was inspecting flares processes. The employee received burns to the front side of the body, face and arm from the flares.

An employee was removing plastic material from a production line when the machine cycled and amputated his left index, ring, and little fingers.

An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.