Struck by object falling from vehicle or machinery-other than vehicle part · Crushing injuries
At a glance
Federal OSHA recorded a severe workplace injury
at Rockett, Inc., 3640 4th Street, FLOWOOD, MISSISSIPPI 39232
on — Crushing injuries, affecting the foot (feet), unspecified.
Final narrative
An employee was using an overhead crane to move a rack upright. The 200-pound rack fell from the crane and crushed the employee's left foot.
HospitalizedFoot (feet), unspecifiedRacks-garment and other
An employee was transporting an 800-pound die on a cart from the tool room. The employee was pulling the cart when it struck a metal plate on the floor. This caused the cart to tip forward and the die to slide off the cart. The die struck the employee's left foot and their second toe was amputated.
An employee was using a forklift to load pallets of product on a trailer. He exited the forklift to adjust a pallet by hand. The pallet fell on him, resulting in an injury to the left leg.
An employee was lifting a 500-pound steel counterweight off a pallet using a magnetic hold jib crane. The counterweight detached from the crane and the employee sustained a left foot/toe fracture that required surgery.
An employee was using a pipe wrench to turn a 42-foot-long steel pipe on jack stands to weld the bottom portion. The pipe fell off the stands, striking the injured employee on his left shin. The employee sustained a left leg fracture at the shin area as well as a tibia fracture that required surgery.
More severe injuries in this industry (NAICS 332439)
An employee was preparing to remove the drive chain of a conveyor motor. Their thumb became caught in the sprocket and chain of the drive motor, resulting in an amputation to the thumb tip between the nail and the first joint.
An employee was working with a drill press when his glove and forearm were caught by the drill bit, resulting in lacerations and fractures to his right forearm. The employee's arm was amputated below the elbow.
An employee was walking on a sidewalk when he stepped off the sidewalk into the grass. As he was stepping onto the concrete parking lot, he tripped over the edge of the concrete and fell onto his left hip. The employee was hospitalized.
An employee was changing the cooling nozzles on an aftercooler and the pneumatic power was activated. This caused the top plate to move into the top position and crush the employee's right arm. The employee sustained a fractured arm.
On October 15, 2024, an employee was cleaning a drum welder with a rag. The machine pulled in the rag and injured three fingers on the employee's left hand. The employee was hospitalized with three partially amputated fingers.
An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.
The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.
An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.
An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.
An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.