Caught in running equipment or machinery, n.e.c. · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at General Cable Corp., 409 Reighard Avenue, WILLIAMSPORT, PENNSYLVANIA 17701
on — Amputations, affecting the fingertip(s).
Final narrative
At about 11:30 p.m. on March 11, 2020, an employee was setting up a drawbench machine to pull aluminum wire. The employee's right ring finger was caught between the wire and the capstan wheel, and the fingertip was amputated.
AmputationFingertip(s)Metal, woodworking, and special material machinery, n.e.c.
An employee was fixing the layer wind of a covered cable on a wooden reel. The employee used his left hand to guide the cable onto the reel. The machine was activated while the employee's finger was under the cable that was under tension. The employee sustained a left middle finger amputation.
Employees were assembling and testing a butterfly valve unit and actuator combo. When the unit was function tested with air, the valve gate closed on an employee's left thumb resulting in a fracture and laceration.
An employee was doing a daily inspection of the sifter screen on a mixer when the mixer line activated. The armature for the screen struck the employee's right wrist. Their wrist was cut and their hand was fractured.
An employee was doing a dry run during the setup of an ice cream machine. The machine indexed and the filler head amputated the employee's left middle finger above the last knuckle.
An employee was on a 3-foot ladder guiding cable onto a spool during installation on an overhead door. As the control box was jogged, the employee's hand was caught between the cable and spool, resulting in a wrist and hand fracture.
More severe injuries in this industry (NAICS 331318)
An employee was adjusting a stretcher. Their foot went between a 3-inch opening on a press. The employee sustained an open fracture of their lower left leg above the ankle.
An employee was standing at a press machine, removing metal from a die cradle that was stuck. Once the metal was removed, the side die closed on his right wrist and lower forearm, breaking bones in the arm.
An employee was pulling metal using a tail stretcher. He pressed the double palm buttons to start the process when the clamp became stuck. The employee pulled on the metal. His left thumb was inside the clamp when it opened, cutting and amputating the tip of his thumb.
An employee was operating a 2 1/2 inch extruder press when aluminum became jammed in the press. Pressure built up and the piece of aluminum shot into the employee's left index finger, resulting in hospitalization and surgery.
An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.
An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.
An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.
An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.