Southwestern Wire, Inc.

Wire began to spool at the top of a draw machine. The injured employee used pliers to move the wire to the bottom of the draw machine. The pliers became caught in the wire and then the employee's glove was caught in the wire, resulting in the amputation of their right index finger at the first knuckle.

An employee was checking the tension of a belt and pulley on a drawing machine when their left hand was pulled into the machine and their fingers were caught in the belt. The employee's index and middle fingers were amputated to the first joint, their ring finger was amputated to the nail bed, and their little finger was fractured.

An employee was setting up a pole and a floor jack to reposition wire inside of the drawing machine. When the machine was turned on, the wire struck the pole, causing the floor jack to kick out. The employee was struck by the jack and sustained a left kidney laceration that required hospitalization.

An employee had been running a weave machine which makes chain link. The employee made an adjustment by tightening a chain to a gear and then went to lunch. Upon returning from lunch, he turned on the machine and noticed the guard on the back of the machine was on the floor. The employee picked up the guard to put it back in place. The gear pulled in his gloved left hand and amputated the pads of the two middle fingers.

An employee fell from a ladder to the ground and sustained a laceration and possible concussion.

An employee was changing mud cups in the hopper cylinders of a concrete pump truck. The cylinders moved and three of the employees fingers were amputated.

An employee was standing on the rig floor next to a polishing unit. His hand was placed on the polishing unit when the pump was lowered, resulting in amputation of their right thumb, ring, and middle fingertips.

An employee was using air to blow out the air wash to the blender and grinder station. As the employee reached to verify that the air wash was clean, the unit pinched and amputated their fingertip.

An employee was retrieving a lost drill pipe with a lifting bail when their left thumb got pinched between the table and handle of the lifting bail while trying to re-thread the pipe to lift it out. The employee suffered an amputation to the left thumb.

An employee was removing a core chuck from a stationary roll when their right ring finger was pinched between the chuck and the roll. The employee's fingertip was amputated.

An employee was changing a section of pipe on a sulfuric acid tank when the pipe broke and acid splashed onto the left side of the employee's body, resulting in chemical burns to their left shoulder, the back of his arm, and his leg.

On August 1, 2025, at approximately 5:05 AM, an employee was applying a label to a spool of product on a crane when the employee s arm became caught between two points of the crane. The employee was hospitalized with a degloving/avulsion injury to their right arm.

An employee was making an adjustment to a machine when his finger got caught in the machine. He sustained a partial amputation to the fifth finger on his left hand.

An employee was working on a wire drawing machine when three fingers on their right hand were caught between the rolls with the wire intact. The employee sustained an amputation to the middle and ring fingers and was hospitalized.

An employee was working at a threader machine. A spindle caught her sweatshirt. She was pulled into the machine, which pulled off her hooded sweatshirt and pulled in her hair. She suffered a scalping and was hospitalized.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.

An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.

An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.

An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.