Reeb Millwork Corporation

While operating a door lifter, an employee became caught on the knob. The employee was lifted up in the air and fell 4 feet when released, sustaining a cut on the leg. The employee received stitches and was kept overnight.

An employee was fixing ceiling tiles while working from a ladder when they fell to the floor and sustained a hip fracture.

An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.

An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.

An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.

An employee was coming down a portable ladder when they slipped and fell to the ground, resulting in a right forearm fracture.

A maintenance employee was troubleshooting and repairing a scissor lift. His hands were on a cylinder when it amputated his right index finger.

An employee was using a staple gun to attach a head onto a door unit when a staple shot into his left wrist, resulting in a puncture wound.

An employee was ripping a 1/2-inch board on a table saw. As the drop piece fell, so did the push stick, and it was pulled into the blade along with the employee's right index finger. The employee's finger was partially amputated. The machine was not guarded at the time of the incident.

An employee was running a piece of wood through a jointer machine. The wood caught and stopped moving, but the employee's left hand kept moving and contacted the blade. The employee suffered a partial amputation to the little finger, below the first knuckle.

An employee was operating a chop saw to cut weather stripping material and suffered amputations to their left thumb and index finger. The employee's middle finger was also lacerated.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.