Caught in running equipment or machinery, unspecified · Soreness, pain, hurt-nonspecified injury
At a glance
Federal OSHA recorded a severe workplace injury
at AJINOMOTO, 5691 Davinci Lane, CARTHAGE, MISSOURI 64836
on — Soreness, pain, hurt-nonspecified injury, affecting the wrist(s).
Final narrative
A metal chip used to test the metal detector had fallen off the conveyor. As an employee reached to retrieve the metal chip, her cotton glove was caught by a sprocket. Her arm and hand were pulled around the bar attached to the sprocket. The employee was hospitalized and had surgery on her wrist.
An employee was removing waste from an onion slicer when the blade contacted their left ring and little fingers. The employee sustained a laceration to a finger and the partial amputation of a fingertip without bone loss.
On December 19, 2023, an employee was setting up a copper wire drawing machine when his left ring finger was pinched between a copper wire and a machine part. The employee's finger was partially amputated.
An employee was checking the gusset seal on a machine. He moved to the next cross sealer and the machine activated, causing an amputation to a left-hand finger. The employee was hospitalized.
An employee was evaluating a coiling machine to verify that the blade was present inside it. The machine's weld function was activated, and the machine crushed the employee's fingers, resulting in the amputation of the left middle and ring fingers.
Two forklift drivers were stopped next to each other and were talking. The injured employee leaned out of their forklift as the other forklift was leaving and they became pinned between the two forklifts. The injured employee was hospitalized with a fractured rib and a lacerated lung.
At about 3:30 p.m. on May 8, 2025, an employee slipped and fell backward while walking around equipment. He landed on the ground, near a water trench into which a steam line and a condensation return line were piped. Hot water from the trench burned his back between the shoulder blades.
An employee was troubleshooting a motor when their right little finger became pinched between the belt and pulley, resulting in amputation of the fingertip.
An employee was driving a forklift to a shipping dock. While he was rounding a corner, a stack of totes fell, and the top of one of the totes struck the outside of his left calf. He was hospitalized.
A crew was preparing a 20-foot section of 12-inch high-density polyethylene (HDPE) pipe to be swung into a welder using an excavator, where it would be welded onto a longer run of pipe. One employee was facing the longer pipe in the welder while the 20-foot section was being rigged. The 20-foot section moved and struck the employee's left knee. The employee's left leg was broken below the knee.
An employee was readjusting a safety hook to remove hardware from gang forms when his feet slipped. He fell to the ground, resulting in a broken left arm and wrist.
An employee was on a step ladder in a store aisle, making room on shelving for merchandise. She fell from the step ladder to the floor, suffering two fractures in her left leg. She was hospitalized, requiring surgery.
An employee was closing the side cargo door to a company van. The tip of his finger got caught between the door and the door jamb, resulting in a partial amputation.
An employee lost his footing while climbing an inclined ladder. He stumbled down one step and was able to stabilize himself by holding the railing and twisting his body, but he suffered an internal abdominal injury and was hospitalized.