Thermo-Twin Industries, Inc.

An employee placed a box of closed-cell extruded polystyrene foam on top of three bundles of aluminum extrusions when two of the bundles fell onto his left leg. The employee sustained a degloving on his shin.

An employee was climbing a 9-foot ladder to put screws in the trim of a window. The employee lost balance and fell from the ladder to the ground, sustaining a broken arm.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

On October 14, 2025, an employee was cutting lumber on an upcut saw. When he activated the saw to cut a short piece, the blade struck the tip of his right thumb, resulting in a partial amputation.

An employee was using a table saw to cut strips of plywood. The employee's left hand came into contact with the sawblade, which amputated the index and middle fingers as well as lacerating the hand. The employee was hospitalized, requiring surgery.

An employee was loading four sliding glass door panels into a truck. He was turning to get a cargo strap when the panels fell onto him and broke his neck.

An employee was using a table saw to cut a small bundle of vinyl material. The saw blade lacerated the employee's left index finger. The employee was hospitalized.

An employee had finished installing hurricane shutters on a customer's home and was putting his tools away and changing clothes. His hands began to cramp; he got out of his truck and collapsed on the road. He suffered an acute kidney injury and rhabdomyolysis caused by dehydration and heat illness.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.