Thermo-Twin Industries, Inc.

An employee was climbing a 9-foot ladder to put screws in the trim of a window. The employee lost balance and fell from the ladder to the ground, sustaining a broken arm.

An employee tripped on plastic while stepping off a pallet. The employee fell, suffering a broken hip.

The injured employee was assisting five other employees with bracing a wall panel that was being stood up. Another employee slipped on frost on the floor surface. The employees went to evacuate the area in anticipation of the wall panel falling over. The injured employee went to jump through a window opening within the wall panel and their lower half was crushed by the falling wall panel. The employee sustained a fractured pelvis.

An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.

An employee was attempting to lift a steel beam from a horizontal, stacked position to a vertical position using a crane. They had placed two hooks on the east side of the beam on the flange. As the employee was hoisting the crane, the beam began to shift and pulled the employee forward onto the stack. When the material shifted, the hooks released and the material fell, pinning the employee between the two beams. The employee was hospitalized with soft tissue contusions on their proximal right thigh and interior left thigh.

An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.

An employee was rigging I-beams. An I-beam slid off the stack of I-beams and fractured the employee's leg.

On October 14, 2025, an employee was cutting lumber on an upcut saw. When he activated the saw to cut a short piece, the blade struck the tip of his right thumb, resulting in a partial amputation.

An employee was using a table saw to cut strips of plywood. The employee's left hand came into contact with the sawblade, which amputated the index and middle fingers as well as lacerating the hand. The employee was hospitalized, requiring surgery.

An employee was loading four sliding glass door panels into a truck. He was turning to get a cargo strap when the panels fell onto him and broke his neck.

An employee was using a table saw to cut a small bundle of vinyl material. The saw blade lacerated the employee's left index finger. The employee was hospitalized.

An employee had finished installing hurricane shutters on a customer's home and was putting his tools away and changing clothes. His hands began to cramp; he got out of his truck and collapsed on the road. He suffered an acute kidney injury and rhabdomyolysis caused by dehydration and heat illness.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.