Sensus USA, Inc.

An employee was clamping a cast iron gas meter housing unit into a hydrostatic test unit. While actuating the clamping mechanism, he was holding the body with his right hand. As the clamping mechanism was clamping, the cap on the outlet end (left side of the body) shifted. At this point, he grabbed the body and cap to prevent it from falling out of the testing machine. His left thumb then became caught between the cap and the hydrostatic test clamping mechanism, causing a partial amputation of his thumb tip.

An employee was fixing ceiling tiles while working from a ladder when they fell to the floor and sustained a hip fracture.

An employee was on an A-frame ladder retrieving materials from a shelf. He slipped and fell and his leg got caught in the ladder rungs, breaking his left tibia.

An employee was unloading materials from a flatbed trailer when they fell from the trailer and landed on the ground. The employee sustained a fractured left leg.

An employee was unloading appliances at a customer location for delivery. The employee was moving a water heater to be placed on the liftgate when he stepped backward and fell to the ground. The employee sustained rib and back injuries.

An employee was coming down a portable ladder when they slipped and fell to the ground, resulting in a right forearm fracture.

An employee was preparing to remove the drive chain of a conveyor motor. Their thumb became caught in the sprocket and chain of the drive motor, resulting in an amputation to the thumb tip between the nail and the first joint.

An employee was working with a drill press when his glove and forearm were caught by the drill bit, resulting in lacerations and fractures to his right forearm. The employee's arm was amputated below the elbow.

An employee was walking on a sidewalk when he stepped off the sidewalk into the grass. As he was stepping onto the concrete parking lot, he tripped over the edge of the concrete and fell onto his left hip. The employee was hospitalized.

An employee was changing the cooling nozzles on an aftercooler and the pneumatic power was activated. This caused the top plate to move into the top position and crush the employee's right arm. The employee sustained a fractured arm.

On October 15, 2024, an employee was cleaning a drum welder with a rag. The machine pulled in the rag and injured three fingers on the employee's left hand. The employee was hospitalized with three partially amputated fingers.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.