Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at AAON INC., 2425 S. YUKON AVE., TULSA, OKLAHOMA 74107
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was loading parts into a foam press using a roll-in/out table. The table was moved by a chain and sprocket system. While the employee was pulling out the parts, the chain and sprocket caught the employee's gloves and amputated the employee's left index finger.
AmputationFinger(s), fingernail(s), n.e.c.Material and personnel handling machinery, unspecified
An employee had staged a forklift and was preparing to release a latch from the attached bin. The latch did not allow the bin to tilt forward. The employee manually pushed the bin while holding the latch open. When the bin bounced back, the employee's left middle finger was crushed, resulting in partial amputation via surgery.
An employee was depositing a piece of sheet of metal into the container of a forklift when the employee was struck by a second forklift. The back tire ran over the employee's left foot and broke it. The employee was hospitalized, requiring surgery.
The injured employee walked out from behind a set of shelves and was struck by a pallet being moved by a forklift. The pallet struck the employee s ankles, causing her to trip and hit her head on either the forklift mast or the pallet. The employee sustained lacerations across the back of her head.
An employee was operating a forklift and dumping scrap metal into a recycling bin. He was picking up metal scraps when a metal pallet slid off the forks of the forklift and caught his right little finger against the scrap bin. The employee's finger was partially amputated.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 333415)
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was observing expansion rods on a coil expander going into a coil to ensure copper stubs weren't being bent. His left hand was caught between the locking block and locking block clamp on the power press machine, resulting in partial amputation of his left little finger from the distal interphalangeal joint.
An employee was setting up a press brake and rolling over a die when the tip of their left little finger was caught between the horizontal working surface of the press brake and die. The employee sustained partial amputation of their fingertip.
An employee was working to remove an access panel to begin performing maintenance on a machine. The set pins on the bottom of the panel were broken. The bottom kicked out and fell, striking the employee's left foot and resulting in a fracture to the big toe.
An employee was helping to move a 1,300-pound coil on a cart. The steel caster hit a crack in the concrete, the weld holding the caster onto the cart broke, and the coil and cart tipped over onto the employee. He was hospitalized with a laceration on his forehead and a pelvic fracture on his right side.
An employee was working in the food service warehouse when he experienced chest pain, difficulty breathing, and lost consciousness. The employee sustained carbon monoxide poisoning.
An employee was cutting a piece of metal rod with a metal cutting machine. His right middle finger became caught between the rod and the machine's table. The employee's fingertip was partially amputated.
An employee was working at her desk. She went to stand up and fell to the floor beside the desk. The employee sustained a hip displacement and required surgery.
An employee was processing wood boards at a chop saw when the saw malfunctioned and the blade cut her left hand and fingers. She was hospitalized and her little finger was surgically amputated.