NEWTON, KANSAS—
Kansas Electric
Small-scale (limited) fire · Heat (thermal) burns, unspecified
At a glance
Federal OSHA recorded a severe workplace injury at Kansas Electric, 1420 NW. 36th St., NEWTON, KANSAS 67114 on — Heat (thermal) burns, unspecified, affecting the multiple body parts, n.e.c..
Final narrative
An employee was working to ignite a scrap wood burn pile using gasoline. When the gasoline caught fire there was a large burst of flame and the employee sustained burns to both arms, a portion of the back, their lips, and hair.
Similar incidents · Same event type
BATON ROUGE, LOUISIANA—
Nuline Utility Services LLC
An employee was standing on a bag of bentonite clay composite when it ignited and the employee's pants leg caught on fire. The employee then went to remove a gasoline can from a dual-axle trailer and sustained burns to his arms, right hand, and the right side of his abdomen.
HOLLISTER, MISSOURI—
Flat Creek Excavating
An employee was burning a brush pile. They poured gasoline on the fire, resulting in burns to his face, arms, and hands.
WYNCOTE, PENNSYLVANIA—
Panda Express Wyncote
An employee was helping to put out a fire in a wok when hot cooking oil splashed onto the employee. They sustained second-degree burns.
SAINT ROSE, LOUISIANA—
Smith Tank & Steel
Two employees were working on an empty above-ground 2,500-barrel crude oil tank. Employee 1 was welding while employee 2 was watching. Employee 1 saw fire behind the welding smoke and notified employee 2. Before they could get off the tank, they both fell in the tank and sustained burns from the fire.
COLUMBUS, MONTANA—
Evolution Pyrotechnics Manufacturing, Inc.
An employee was pressing pyrotechnic composition into pellets using a pressure tablet press. Upon pouring the composition into the small hopper, the composition ignited and produced a flash fire. The employee sustained bilateral burns to the hands and face.
More severe injuries in this industry (NAICS 238210)
WASHINGTON, DISTRICT OF COLUMBIA—
Smart Building Technologies - A Fidelity Company
An employee was troubleshooting the control setup for a variable air volume box above a ceiling. The employee's hand came into contact with an exposed, energized 277-volt wire that had loosened from its terminal on the box's assembly. He was shocked and fell off a ladder. His left hand passed across the ceiling grid and was lacerated. He also suffered an electrical burn to the right hand and was hospitalized.
CANTON, OHIO—
Abbott Electric Inc
An employee was moving a scissor lift through a doorway. The employee was pinned between the scissor lift and the doorframe, sustained a back injury, and was hospitalized.
AVENTURA, FLORIDA—
Mintcrest Corp
An employee was standing on an A-frame ladder approximately 6 feet above the floor while he attached a suspended light fixture to the ceiling. The employee lost balance, and fell to the tiled floor below, sustaining blunt force trauma to his head.
KUNA, IDAHO—
Cupertino Electric, Inc.
An employee was inspecting the overhead area of a single-person lift and repositioning the lift through a double doorway. As they were transitioning through the doorway, they were caught between the doorframe and the vertical mast of the lift. The employee was hospitalized with injuries to the nose, left maxillary sinus, left orbital bone, and left jaw, with fractures at the maxillary sinus area.
AURORA, ILLINOIS—
Swedberg Electric, LLC
The injured employee was performing routine maintenance on a fan belt/pulley. The injured employee and another person were moving the pulley back and forth manually to find a bearing issue. The injured employee's left ring finger got caught between the belt and the pulley wheel, resulting in a soft tissue amputation.
More severe injuries in KANSAS
WATHENA, KANSAS—
Omya Inc.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
COFFEYVILLE, KANSAS—
John Deere Coffeyville Works
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
HAVEN, KANSAS—
Haven Steel Products Inc
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
MINNEOLA, KANSAS—
Vestas-American Wind Tech
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
MEADE, KANSAS—
Alliance Ag and Grain LLC
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.