Struck by swinging or slipping object, other than handheld, n.e.c. · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at NRG Energy Powerton Generating Station, 13082 E Manito Rd., PEKIN, ILLINOIS 61554
on — Cuts, lacerations, affecting the elbow(s).
Watch NRG Energy Powerton Generating Station — freeGet an email when a new federal OSHA severe-injury report for NRG Energy Powerton Generating Station is published. One employer, no account, unsubscribe in one click.
Final narrative
On August 23, 2020, an employee was checking the pressure on compressed oxygen cylinders used for boiler chemistry control. When the employee opened a cylinder manifold valve, the stainless steel braided hose connecting the cylinder cradle to the pressure gauge failed and whipped around, striking the employee on the back and the left elbow. The employee suffered a 6-inch laceration to the elbow and was hospitalized.
A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.
An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.
The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.
An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.
An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.
More severe injuries in this industry (NAICS 221112)
Employees were pulling three-phase power lines to a power pole. An employee's hand was caught between a pulley and a rope, resulting in amputation of the employee's index, middle, and ring fingertips.
An employee was cutting through two secondary wires with a battery-powered cutting tool. The wires were energized at 120/240 volts; when the employee cut through the insulation around a wire, an arc flash burned the employee's left thumb.
An employee had been preparing material for a lineman at a jobsite and was pulling up wire on a hand line. The employee began to feel ill, suffering from heat illness.
An employee was tamping at the base of a power pole when they were struck by an extendable hot arm that was dropped from an aerial bucket. The employee sustained two broken ribs on the right side, and a pneumothorax on the right side.
An employee was changing a die in a press when the die slipped and crushed the employee's left index finger. The employee sustained an open facture of the tuft of the left distal phalanx and a partial amputation.
An employee was driving a boom lift (in the lowered position) in an exterior dock area. The lift s left wheels rolled onto base plates that covered a 3-foot-deep sump pit. The base plates failed, and one side of the lift dropped. The employee's left leg was caught under the lift basket, and he suffered a fracture to the lower leg including the ankle.