Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Senox Corporation, 227 South Town East Boulevard, MESQUITE, TEXAS 75149
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
While working on a metal slitter machine an employee sustained an amputation to the right index finger and a laceration to the right middle finger.
An employee was operating a machine on a paint line. They were helping to remove aluminum from the machine and re-thread it when they took a step and contacted hot water in a wash tank, resulting in burns to their left foot.
An employee was moving an aluminum coil from a coil tilter. The coil fell, striking the employee's left leg. The employee suffered swelling to the leg.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 332114)
An employee was jogging a steel coil into a roll former to prepare the machine for a run. The coil started to slip, so he used his left hand to pull on it. His glove was pulled into the roll tooling, which crushed his left middle, ring, and little fingers. The employee sustained amputations to his left ring and little fingers.
An employee was operating a machine on a paint line. They were helping to remove aluminum from the machine and re-thread it when they took a step and contacted hot water in a wash tank, resulting in burns to their left foot.
A maintenance employee was troubleshooting an issue on a bundler machine when the machine actuated, striking and fracturing their right leg. The machine was not guarded or locked out at the time.
An employee was performing repairs on a crimping machine when their thumb and index finger were crushed in the crimping mechanism. The employee sustained an amputation to the finger.
An employee was maneuvering a 350-pound roll from a skid to a forklift. The roll fell onto the employee's hand, resulting in a partial right finger amputation.
After cutting a slab of beef short ribs, an employee turned to grab the pieces he had cut and his right hand contacted the saw blade. The employee sustained an amputation to his right index finger.
An employee was unloading a carpet pad from a truck when they fell from the truck dock to the concrete below, resulting in five fractured ribs and an injury to their left lung.
An employee was walking up a walkway to enter a building through the back entrance when she tripped over the lip of the cement ramp. The employee fell and sustained a fractured right hip.