Caught in running equipment or machinery during regular operation · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at Dakota Bodies, LLC, 201 20th Avenue SE, WATERTOWN, SOUTH DAKOTA 57201
on — Amputations, affecting the finger(s), fingernail(s), n.e.c..
Final narrative
An employee was changing out dies on a hydraulic press brake. As the employee was trying to move the plastic die in the point of operation, the brake closed on the employee's left-hand fingers. The two middle fingers were later amputated to the knuckle.
An employee was sharpening peeler blades when their shirt was caught in the grinding wheel. The employee sustained tendon damage and a crushed right hand.
An employee was preparing to cut lumber on a panel saw when the clamp engaged and caught the employee's left middle finger, resulting in a fingertip amputation.
More severe injuries in this industry (NAICS 336211)
An employee was walking on a dock plate to open the door for the next trailer. He tripped on a cargo strap that was laying on the dock and fell. The employee sustained a fractured right hip, requiring hospitalization and surgery.
On September 18, 2025, an employee was rolling a stack of two steel racks containing automobile bumpers when the top rack dropped, pinching their right little finger. The employee suffered a partial amputation.
An employee was exiting an ambulance when his foot slipped, causing him to hit either the portable aluminum step or the concrete floor. He suffered a broken left elbow.
Two employees were sliding a 200-pound steel mounting plate off a worktable onto the forks of a forklift. They slid the plate until it was half on the table and half on the forklift, and were making an adjustment to get the plate fully on the forklift when the plate pinched one employee's left ring finger. He suffered a partial amputation to the fingertip.
An employee was moving a tensile strength test device with a dolly. The device fell from the dolly onto the employee's right leg, causing a compound fracture.
An employee was walking past a crossover conveyor when a ramp came down and hit them in the back. The employee sustained a broken back vertebra, as well as a concussion, and was hospitalized.
An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.
An employee was walking on a truss table when he lost his balance and fell approximately 3 feet to the floor. The employee sustained a dislocated and fractured left ankle.