RNC Industries LLC

An employee was on a podium ladder using a tool to grind a wall. The employee fell 6 feet onto stacked lumber materials and steel bracing channels, resulting in right hip and thigh pain.

An employee was on the platform of a 4-foot high platform step ladder to install reshoring for pour-in-place concrete construction. The employee fell approximately 4 feet from the platform to the floor and sustained a back injury.

On August 12, 2020, an employee was walking at a construction site when his foot fell into a hole and he tripped. He landed on a piece of metal, suffering a broken femur.

An employee stepped on a piece of loose plywood and fell through the floor.

An employee was walking to their truck to look for a lid. When they stepped between the truck and a dock plate, they sustained a knee injury that required surgery.

An employee was standing on plant bed timbers, using a powered hand trimmer to trim the shrubs in the plant bed. The timber gave way, breaking into several pieces. The employee lost balance and fell with the trimmer in his hand. He suffered a severe laceration to the right wrist and hand.

A mail carrier slipped on ice and sustained a strain that required hospitalization.

An employee was loading phosphoric acid onto a rail car and preparing to secure the rail car for transport. While repositioning the loadout spout to secure it back to the drip pan holster on the dock, the spout contacted the handrail of the rail car, causing the employee to lose balance. The employee stepped back and their right foot entered the opening for the rail car, causing him to twist/pivot on his left leg. The employee's lower left leg was fractured.

On November 14, 2023, an employee was receiving a delivery from a truck when some of the merchandise fell from the truck s lift and struck him. He then fell to the ground and his head struck the sidewalk, resulting in an injury that required hospitalization.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

An employee was standing on an extension ladder, using a torquing tool to remove bolts that secured blades to a rotor. When the torquing tool activated, its reaction arm came around and pinched the employee's right middle finger against a lifting eye. His fingertip was amputated.

Employees were securing the fuel line of an outboard motor in preparation for removing the motor from a small vessel located in the equipment yard. A gasoline-related fire occurred and one employee sustained burns to both hands and forearms.

A marine diver/construction worker was working underwater, using a hydraulic dredge to clear sediment away from the base of a dam. The dredge's suction nozzle began migrating toward him, and then pulled in his right hand and forearm. He sustained compartment syndrome in the hand and forearm.

An employee was standing on a sheet of -inch by 4-foot by 8-foot plywood on top of a rebar mat, supervising his crew. As he was moving to alert the crew to an incoming overhead load, he stepped off the plywood and his left foot slipped through the rebar mat and landed on the rebar mat below. His left ankle was broken and dislocated.

An employee was cleaning leaves with a backpack blower when he fell from a ladder, resulting in injuries to his head, neck, and back.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee slipped while descending in a stairwell, fell, and suffered multiple contusions/bruises to the head, neck, shoulders, knees, and back. She was hospitalized.

An employee's right middle finger was caught in a nip point. The employee suffered an amputation to the middle finger at the first knuckle.

An employee was directing trucks as they entered and left a highway work zone. A vehicle struck them, resulting in multiple fractures and other injuries. The employee was hospitalized.