Kautz Construction

An employee was installing a 15-amp breaker in an electrical panel when a 12-gauge ground wire touched the positive busbar of the panel, resulting in an arc flash. The employee sustained a second-degree burn to their left hand.

An employee was repairing an HVAC system in the drop tile ceiling of a conference room when they were shocked, causing them to fall from the ladder. The employee sustained burns to their right middle and ring fingers.

An employee was replacing a contactor inside an electrical panel attached directly to a press. The press itself was receiving power from another main panel. After replacing the contactor, the employee flipped the switch and an arc flash occurred, burning the employee's elbow, bicep, and neck.

An employee was attempting to switch a medium-voltage primary cable and install a 200-amp fuse barrel. The employee contacted the bottom of the switch gear cradle for the fuse barrel, causing an arc blast. The electricity entered the employee s left hand and exited his big toes, resulting in electric shock and burns to the left hand, arm, shoulder, and both feet. The employee was hospitalized.

On December 6, 2023, an employee of Duke Energy was working on a single-phase 120-/240-volt parallel service re-tap when a secondary flash occurred in an underground service. The employee suffered a second-degree burn to the face and was hospitalized.

Employees were at the trucks to leave for lunch. The injured employee was putting the cone back after the crew leader pulled the truck forward from the designated worker parking area. The injured employee then ran back to the truck. As he went to get in the truck, he said the upper thigh area of his leg was hurting. He laid on the ground outside the truck and crew leader could see a bump/bulge in the the injured employee's upper thigh area below his hip. The employee sustained a fractured femur and required surgery.

An employee was helping a contractor unload a delivery of two new dock plates from a trailer onto a forklift. The employee s left index and middle fingers were pinched by the dock plates, resulting in amputations to both fingers above the first joint.

An employee was helping to load a customer's truck. The employee stepped toward a forklift to get paperwork from the driver. The employee's right lower leg and foot were run over by the back tire of the forklift. The employee was hospitalized with fractures to his lower right leg.

An employee was moving wet bundles of shingles on a truck bed, when one of the bundles slipped out of his hands. He tripped over a pallet, fell off the bed of the truck, and landed on his left side. The employee sustained fractures to three ribs, and a displaced iliac fracture.

On August 12, 2025, an employee was loading shingles onto the roof of a new-construction home when be began to suffer from heat exhaustion and dehydration.

An employee was closing a door when the door closed on their right index finger, resulting in a fingertip amputation.

An employee was walking into the motor control center (MCC) room when his right ring finger was caught in the hinge of a doorway. He sustained an open phalanx fracture, which resulted in a partial amputation above the first knuckle.

An employee was changing the spacing on a telehandler's forks. A fork slipped, and the employee's left index finger was caught between it and the mast. The fingertip was medically amputated at the first knuckle.

An employee was pulling down a broken skid with a forklift. When the employee backed up the forklift to get the forks out of the skid he pulled down, he contacted the forks of another parked forklift, fracturing both of his legs. He was hospitalized.

An employee was carrying cups back to the kitchen when her foot got caught on a cart and she fell face-first. During the fall, a piece of glass from a cup cut the inside of her mouth, severing an artery. She also sustained a laceration on her lower lip. The employee was hospitalized.