Joe McGee Construction

An employee was traveling down an aisleway in a three-wheeled golf cart. They were moving around a parked forklift when a material cart came from the opposite direction. A wheel on the material cart caught a piece of racking causing the material cart to swing out and hit the injured employee's golf cart. The material cart continued to swing, hitting the injured employee's left leg. The injured employee was also knocked out of the golf cart and landed on the ground 2-3 feet away. The injured employee sustained fractures to the left leg, requiring hospitalization and surgery.

Employees were operating a baggage tractor on a service road. The tractor made contact with an aircraft's left wing and the seat of the tractor was ripped off. The employees were thrown to the ground. Two employees were hospitalized with injuries including a chipped tooth, bruises and abrasions, a dislocated hip, a fractured humerus bone, and a laceration to the left knee.

An employee was driving his vehicle (golf cart style) to an aircraft when he passed by two large baggage carts and was T-boned by another vehicle. He was hospitalized with a broken left leg.

An employee was operating a forklift, which had a T-bone collision with another forklift. The employee suffered four broken right ribs, a bruised right lung, and skin bruising and was hospitalized.

An employee was driving a dead forklift being pushed by a second forklift when the second forklift's forks slipped and hit the employee's foot. The employee was hospitalized due to crushed bones in the foot.

An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.

An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.

A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.

An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.

An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.

An employee was checking a pole-type transformer tank for leaks. A hydraulic clamping device was lowered onto his right thumb and crushed it against the sharp edge of the bottom of the tank. He suffered a partial transphalangeal amputation to the thumb.

The injured employee was standing behind a table. She jumped out to scare another employee, but tripped and fell on the tile floor, injuring her right ankle/foot. She was hospitalized with a dislocated ankle that required surgery.

An employee was going into a trailer to mark product for shipment and the trailer pulled away from the dock. The employee fell out of the trailer, contacted the dock plate, and then fell to the ground. The employee was hospitalized with a punctured lung, fractured ribs, and contusions.

An employee was hooking up bundled tie-downs with a chain. While he was holding a hook, the other hook was unlocked. This caused the employee's hook to slide down and pinch his right index finger between the chain and the shackle. He suffered an amputation to the fingertip (without bone loss), as well as an open fracture.

An employee was operating a gas tugger to lift metal sheeting. His left hand was pulled into the pulley, which crushed his left thumb, resulting in avulsions and other tissue damage. He was hospitalized and required surgery.