Struck against moving part of machinery or equipment · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at The Ottawa Cooperative Association, 521 Locust, OTTAWA, KANSAS 66067
on — Fractures, affecting the lower leg(s).
Final narrative
An employee was working in a grain bin when the employee made contacted with the auger, resulting in a right leg amputation below the knee.
AmputationLower leg(s)Agricultural and garden machinery, n.e.c.
An employee was operating a strip saw. As the employee shut off the saw, their right index and middle fingertips were amputated by the blade before it came to a complete stop.
An employee was using a table saw to cut a piece of wood for wall framing. The wood jumped, causing the employee's hand to move toward the saw, amputating their left index finger and causing a laceration on their hand.
An employee was operating a trim saw. While trying to free a jammed board she had just cut, she came into contact with the running saw blade, which amputated her right thumb.
An employee was fixing an issue with seed cleaning equipment when he slipped on the ladder he was on. He went to catch himself and his hand went into a moving belt and pulley on the cleaner. The employee sustained the amputation of his right middle and index fingertips just below the fingernails.
At about 5:30 p.m. on September 23, 2025, an employee was unloading rubber mix material from a mixer. The employee's hand was caught by rotating parts in a discharge chute, causing a partial, soft-tissue amputation to a fingertip.
An employee was walking around a customer's truck. The truck door opened and caused the employee to trip and fall on a salt pallet. The employee suffered a compound fracture to the left arm.
An employee had delivered product to a customer and was driving a forklift to the rear of the delivery truck. The forklift jumped/bounced, sending the employee up into the air and back down onto the seat. The employee sustained a back fracture.
An employee was climbing an inspection ladder to observe the inside of a hopper. He slipped on the fourth rung, fell backward, and landed on his right foot on the ground about 38 inches below, suffering a broken right ankle.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.