Port Newark Container Terminal

An employee was driving a checker vehicle when it collided with a truck that was backing up. The employee suffered a right superior articulating facet fracture of the C6 vertebra, a fracture of the left posterior tubercle at the C5 vertebra, a grade IV blunt cerebrovascular injury with distal reconstitution, abrasions to the left ear and left elbow, and decreased sensation in the right thumb and index finger.

An employee was struck by a truck's rear wheel while directing traffic. The employee suffered a broken shoulder and severe abrasion to the back and neck.

A crew was pulling a 4-inch plastic gas pipe off a reel and straightening it for installation. The injured employee stepped up on the trailer to cut the last band holding the pipe in the coil on the reel. As he turned to step off the trailer, the end of the pipe rotated and sprung out of the cage surrounding the coil, striking the employee on the side of the head and knocking him off of the trailer into the roadway. The employee suffered head trauma that required hospitalization.

An employee and a co-worker were performing a pick inside a clear well. They rigged the skid pan that was full of broken concrete. When lifting, the load began to swing toward a wall. The employee tried to stop the skid pan from swinging and was struck by the pan, resulting in fractures to their left hip and wrist.

The employee had just completed refueling a lattice crane that was breaking up material and was winding the fuel hose back into the fuel truck when he was struck by the catwalk/stairs of the crane. The employee was hospitalized with a laceration to his backside, possible internal bleeding, and a broken hip.

An employee was fusing 10-inch black rubber utility pipes together using a pipe fusion machine and could not get the pipes to set correctly. The employee used a nylon strap attached to an excavator to lift one side of a pipe off a steel plate. As his hand was between two pipes, the pipes came back together, partially amputating two of his fingers.

An employee was lifting four bags of a lime blend weighing approximately 10,000 pounds using a crane. The load swung and pinned the employee against a structural I-beam, resulting in fractures to the hip and pelvis.

An employee was operating a rider pallet jack when it struck a stand-up forklift. The forks struck both of the employee's ankles, resulting in hospitalization.

An employee was working to repair a machine with a broken metal stopper. She removed the stopper and used a roll of tape to temporarily secure it. While she was moving it back into place to fix the machine, the residual pressure of the plastic pallets forced the stopper down, resulting in her right thumb becoming stuck between two metal parts. The thumb was amputated.

An employee was changing the battery on his forklift. He removed the forklift's battery plate and exited the battery machine alignment track. The shift lead then went to retrieve a new battery. The employee entered the battery machine alignment track again to unplug the charging cable. The battery changing equipment proceeded forward and pinned the employee against the forklift. The employee was hospitalized with two fractured ribs.

An employee took a picture of the seal and license plate on a delivery truck after loading. The truck then reversed back to the dock and pinned the injured employee against the dock. The employee sustained an abdominal fracture.

An employee was using a hook tool to pull a pallet onto the lift gate of a tractor trailer. The hook detached from the underside of the pallet, causing the employee to fall backward off the lift gate. The employee landed on the concrete parking lot about 5 feet below, suffering fractures to the skull and two thoracic vertebrae.

An employee tripped over a stool and fell on the floor, resulting in a left displaced mid-cervical femoral neck fracture.

An employee was installing fence posts when they stepped into a recently dug hole that was not visible due to rainfall. The employee's leg was fractured.

An employee assisted in cleaning material from a conveyor pit. After the pit was cleaned, the employee proceeded to replace metal safety plates to ensure other employees did not fall into the pit. While replacing one of the last plates, the employee mis-stepped and fell approximately 5 feet into the pit. The employee was hospitalized with back/side bruising, elbow bruising, bone bruises, and/or fractured ribs.

An employee was inspecting a breaker box and turning on/off a circuit breaker when he was electrocuted.

An employee was walking on the sidewalk. When they stepped off the curb, they fell to the ground, resulting in fractures to their tibia, fibula, and a metatarsal.