Injured by slipping or swinging object held by injured worker · Cuts, lacerations
At a glance
Federal OSHA recorded a severe workplace injury
at KLIKLOK LLC, 5224 Snapfinger Woods Drive, DECATUR, GEORGIA 30035
on — Cuts, lacerations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
An employee was drilling holes in a piece of tube steel. As he was repositioning the material, it shifted, trapping his finger against the drill bit. The drill bit caused a laceration requiring hospitalization and tendon surgery.
An employee was coming off a four-step ladder. At the final step, he fell backward to the floor. His head struck the corner of a nearby parts cart and was lacerated.
An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.
An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.
An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.
More severe injuries in this industry (NAICS 333993)
An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.
An employee had just driven a forklift onto a trailer and was stepping down from the forklift cab onto the trailer bed. He stepped onto a chain/buckle system (used to secure the forklift to the trailer bed during travel) and fell from the deck. He suffered a head laceration and two broken vertebrae and was hospitalized.
The injured employee was leaving to go to lunch when he and another employee tried going through the office door at the same time. The employees bumped into each other and the injured employee lost his balance and fell to the ground. He was hospitalized with a broken hip.
An employee was pushing mailers when the arm/knife of a picking counter machine caught their hand. The employee suffered the amputation of their right middle finger above the knuckle. The machine was not sufficiently guarded.
An employee was using a belt sanding machine to put a 45-degree angle on the end of a metal flat-bar (1"W x 24"L x 3/8"T). The flat bar was caught between the tool-rest and the belt, causing the opposite end of the flat bar that the employee was holding to spring back toward the machine. Their left hand struck the belt/machine guard resulting in amputation of 3/4 of their little finger. Their ring finger was also lacerated.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.