KLIKLOK LLC

An employee was drilling holes in a piece of tube steel. As he was repositioning the material, it shifted, trapping his finger against the drill bit. The drill bit caused a laceration requiring hospitalization and tendon surgery.

An employee was climbing a step ladder while carrying a 3-foot piece of conduit. As he went to reposition his feet on the ladder by pivoting, he slipped and fell from the third rung of a 6-foot ladder. The employee sustained fractures to the left femur, right elbow, and right ring finger.

An employee was descending a 4-step maintenance stand when she missed the bottom step and fell to the hangar floor. The employee suffered a left hip fracture.

An employee stopped a belt and was going to check it for missing packages. She fell backward 3-4 feet from an elevated platform and sustained a broken right arm.

An employee had just finished a routine concrete pour and was ascending the ladder to clean the concrete mixer truck. The employee lost their grip and fell approximately 2-3 feet, contacting the truck's bumper. The employee suffered rib fractures and a punctured lung.

An employee was performing duties as an expeditor. After opening the dock door, the employee scanned the barcode on the door of the truck and placed one foot on the truck and one foot on the dock. The truck drove out of the stall, causing the employee to fall 4 feet off the dock onto the concrete. The employee sustained fractures to the right side of the pelvis, elbow, and a left ring fingertip as well as injuries to the right wrist and bruising to the back and stomach.

An employee was moving a stand-up powered industrial truck from a warehouse to a service area. During a turn on a slight decline, the vehicle's steering chain broke and the vehicle spun. The employee fell off the vehicle and landed on his right knee, breaking his fibula.

An employee had just driven a forklift onto a trailer and was stepping down from the forklift cab onto the trailer bed. He stepped onto a chain/buckle system (used to secure the forklift to the trailer bed during travel) and fell from the deck. He suffered a head laceration and two broken vertebrae and was hospitalized.

The injured employee was leaving to go to lunch when he and another employee tried going through the office door at the same time. The employees bumped into each other and the injured employee lost his balance and fell to the ground. He was hospitalized with a broken hip.

An employee was pushing mailers when the arm/knife of a picking counter machine caught their hand. The employee suffered the amputation of their right middle finger above the knuckle. The machine was not sufficiently guarded.

An employee was using a belt sanding machine to put a 45-degree angle on the end of a metal flat-bar (1"W x 24"L x 3/8"T). The flat bar was caught between the tool-rest and the belt, causing the opposite end of the flat bar that the employee was holding to spring back toward the machine. Their left hand struck the belt/machine guard resulting in amputation of 3/4 of their little finger. Their ring finger was also lacerated.

An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.

A casting machine jammed. An employee's hand was caught in the machine, where a belt line caught and amputated the tip of his finger.

During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.

An employee slipped on condensation on a walkway in a parking garage. She fell and suffered a closed fracture to the neck of the left femur.

An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.