Federal OSHA recorded a severe workplace injury
at C. W. Matthews Contracting Co., Inc., I-75 North, JULIETTE, GEORGIA 31046
on — Cuts, lacerations, affecting the head, unspecified.
Final narrative
A crew had finished paving a 1200+ ft. stretch of interstate. While the paver was being backed up to its starting point, the paver suffered an unknown mechanical failure that caused the engine to stall. The paver lunged forward and an employee on the paver lost his balance and fell forward onto the floor of the paver seating area. The employee struck his head on the metal handrail, causing a laceration to the head.
HospitalizedHead, unspecifiedAsphalt and concrete paving machines, pavers
More severe injuries at C. W. Matthews Contracting Co., Inc.
On August 13, 2025, an employee was marking out line and grade for an inlet box. While he was stepping from one 18-inch reinforced concrete pipe to another, his foot slipped and he struck the pipe and fell. He suffered a broken left tibia.
On March 28, 2025, an employee working as a machine operator was changing the teeth on a milling drum. He was using the tooth extractor when his left index finger became caught between the drum and the extractor. The employee's fingertip was amputated.
A traffic control crew was picking up road barrier barrels and loading them onto a trailer. A box truck rear-ended a police car, struck the traffic control trailer, and struck two traffic control employees. One of the employees was hospitalized with a severe laceration to their liver and fractures to their right tibia and fibula, as well as their left arm.
An employee was pulling the joint off a southbound lane and checking the depth. The employee was walking on the right side of the paver when a vehicle swerved into the closed lane and struck the employee, launched him into the air, where he struck a spreader. The employee sustained a contusion to the body, a right arm laceration, a fractured right tibia, and a right leg laceration. The driver of the vehicle was arrested for driving under the influence (DUI).
On October 26, 2023, two employees were performing construction work when they engaged in a physical altercation. One employee was hospitalized with a brain bleed and a back injury.
An employee was treating a patient in the back of an ambulance. The ambulance stopped quickly and the employee suffered a fractured C7 vertebra and bruises.
On or about September 14, 2016, an employee was a passenger in the company shuttle bus, commuting from the employee parking lot to the building. The company shuttle bus quickly braked to avoid another vehicle and the employee slid forward, striking her left abdomen on the seat in front of her.
More severe injuries in this industry (NAICS 237310)
An employee was operating a battery-powered broom to clean demolition debris off the top of the outermost bridge girder. The girder was approximately 11 feet above the demolition scaffold below. The employee fell approximately 8 feet to wind bracing below. The employee was hospitalized with a pelvis/tailbone fracture. Fall protection was in place at the time.
An employee was cleaning out an inlet pipe in a stormwater structure. The employee stepped back, fell into the pipe, and landed on concrete 13 feet below, at the bottom of the structure. He suffered a broken back.
A concrete batch plant operator was assisting with clearing spoil piles using a skid steer. The skid steer backed into a stationary screen plant. The employee's left little finger was crushed between the controls of the skid steer and the screen plant, resulting in a fracture and laceration. The employee's finger was surgically amputated.
An employee was operating a roller and paving a small pathway next to a pavilion. The ground was on a slight pitch, causing him to reach up toward the roll cage to stabilize himself. His right fifth finger was pinched between the roll cage and the rafter of the pavilion. The employee sustained a partial degloving injury with partial traumatic amputation.
An employee was working with paving equipment and heard a noise on the opposite side of the machine he was working on. When the machine stopped, the employee went to the opposite side and crouched down to investigate the noise. A mini track loader backed up and drove over the employee's leg. The employee sustained fractures to their lower leg, ankle, and foot.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.