4 Points Excavation & Underground

An employee was using a saw to cut a piece of concrete when the piece gave way and pushed the saw into the employee's leg. The employee's leg was lacerated, requiring stitches and hospitalization.

An employee was using a utility knife to cut honeycomb paper when the knife amputated their left index fingertip.

An employee was cleaning a resident's chimney. While using a drill, the employee's glove became caught in the drill and their finger was fractured.

An employee was grinding some hardfacing on a bulldozer blade when the 9-inch grinder kicked back and lacerated his left leg above the knee. The employee was hospitalized and required surgery.

An employee was operating a rotating tool to place thread protectors on the end of pipe. Her left hand was on the rotating part of the tool when the tool engaged, resulting in a left forearm fracture and a thumb laceration.

A crew was relocating a dumpster (containing approximately 200 pounds of demolished wire) to access the uninterruptible power supply (UPS) units they were servicing. During movement of the dumpster, a section of carpet tile dislodged from the floor, causing an employee to lose his footing, slip, and fall. He landed on his right wrist, resulting in a fracture.

An employee was cutting a board using a circular saw. The saw pinched, kicked back, and cut the employee's left ring and little fingers. The employee suffered an amputation to the little finger.

An employee was using an aluminum extension ladder to remove gutters at a height of approximately 20 feet. As they were removing the gutters, part of the gutter collapsed and struck the ladder, causing it to move sideways. The employee fell from the ladder and sustained fractures to ribs on the left side and their right forearm.

An employee was using an electric saw to cut a piece of wood for a fence. The saw slipped out of his hand and lacerated his left leg. He was hospitalized.

An employee was erecting a scaffold. A side bracket was not secure. The employee stepped on the bracket to test it and fell 18 feet to the concrete floor resulting in fractures to the ankles and femurs. He was not using fall protection equipment.

An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.

An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.

An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.

Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.

An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.