Fall through surface or existing opening, unspecified · Fractures
At a glance
Federal OSHA recorded a severe workplace injury
at Alphia, 100 N Youngman Ave, BAXTER SPRINGS, KANSAS 66713
on — Fractures, affecting the pelvis.
Final narrative
An employee had been working on a hot water heater located above an office. The employee fell through the roof in the shipping area, landed on the floor, and sustained a broken pelvis.
An employee was power washing a metal tank from an elevated platform. They fell through a gap between the platform and the tank. The employee landed on the ground and sustained fractures to their ankles and feet.
An employee was installing a metal roof when he stepped on a skylight. The employee fell through the skylight to the ground, resulting in head and shoulder fractures.
An employee was replacing an HVAC unit in a residential home. While he was in the attic space above the garage, the wood he was walking on broke, causing the employee to fall through the sheetrock to the concrete floor below. The employee bumped his head and sustained a shoulder injury as well as a broken ankle.
An employee was putting a tarp on a water tank while standing on a trailer. She lost her footing and fell through the trailer bed, striking the corner of the trailer bed. The employee sustained internal bleeding.
An employee was repairing a sub-floor in a residential house that had water and fire damage. The employee fell through the sub-floor and landed in the basement, resulting in spinal fractures that required hospitalization.
More severe injuries in this industry (NAICS 311111)
An employee was working to remove a spatula that got stuck in an auger at the bottom of a hopper. The employee went to remove the face plate to help release the spatula. His fingers were in the holes to pull off the face plate when the machine actuated. His right middle finger got trapped between the face plate and the inner plate, resulting in amputation.
An employee was walking in a parking lot during break when they were struck by a vehicle, resulting in fractures to their left scapula and lower right leg.
An employee bent down to turn on an air valve, lost their footing, and struck their hand on a pressure relief valve while trying to catch themselves. The employee suffered an amputation to their right index fingertip.
An employee was working on a production line, packaging chews for animals. She retrieved a fallen cap for another production line from the floor and went to put in back in the machine it had fallen from (a capper). The machine caught the tip of her left little finger, causing a fingertip amputation.
An employee was taking apart the piping to a meat pump for clean-up. He saw food debris inside the pump housing and went to remove it. The meat pump rotor caught and severed his right index and middle fingertips, resulting in partial fingertip amputations.
An employee was working to remove a product blockage from a piece of equipment. The employee was struck by a metal bar near the deck of the pin mixer equipment and sustained blunt force trauma to the torso.
An employee was moving a rack onto a lower conveyor in the south heat treat area when their finger got caught between the part tray and the rollers, resulting in a fingertip fracture and amputation.
An employee was climbing a ladder to get on top of the breakroom. The ladder slipped, causing him to fall to the ground. The employee sustained fractures to his upper back, left foot, and ankle.
Two employees were removing a circuit breaker. The injured employee was using wrenches in the removal process. One of the wrenches contacted an adjacent door, resulting in an arc flash. The employee suffered burns to their neck, face, and ear, as well as momentary vision loss due to the flash.
An employee bent over to pick up a rubber mat from the ground. When he grabbed the corner of the mat, a rattlesnake hidden under it bit his left middle finger near the first knuckle. He was hospitalized.