Contact with hot objects or substances · Second degree heat (thermal) burns
At a glance
Federal OSHA recorded a severe workplace injury
at BITUMAR (GEORGIA), INC., 7982 Huey Rd., DOUGLASVILLE, GEORGIA 30134
on — Second degree heat (thermal) burns, affecting the head and neck.
Final narrative
While assisting a coworker, an employee was cracking a suction line to determine if hot asphalt was unloading from a truck when they were sprayed with the 460 degree hot asphalt. The employee sustained second degree burns to the left side of their nose, cheek, ear lobe, chin, and part of their neck.
HospitalizedHead and neckPaving asphalt, asphaltic cement
An employee connected a steam line to a hose to clean equipment when the fitting broke loose. They were struck by steam in the left inner thigh, resulting in burns that required hospitalization.
An employee was making tea when she noticed tea grinds were collecting on the side and water was no longer dripping through the funnel. The employee was checking the funnel when boiling water and tea grinds spilled onto the left side of her body. The employee sustained burns to her neck, back, and arm.
An employee had turned off the ball valve on a waterpipe system and was removing the plug when the coupling system attached to the strainer came apart. Hot water sprayed on his arm and back, resulting in first- and second-degree burns that required surgery.
An employee was using a shovel to remove waste vermiculite from molten zinc. The metal had been placed in a bin and partially hardened. The employee broke through the partially hardened metal; still-molten metal flowed to the employee's steel-toed right boot and entered through the cloth boot tongue. The employee suffered a third-degree burn to the right foot and was hospitalized.
More severe injuries in this industry (NAICS 324122)
An employee was coming from the parking lot at the start of his shift. He fell while walking in the crosswalk and sustained pain and numbness in his right leg. The employee was hospitalized and required surgery.
Employees had just finished re-lacing a line through a machine. As they were preparing to make a splice, one employee's left index finger was crushed between two pull rollers. The finger was amputated.
An employee was replacing a pop-up roller between the drop plate table and the far stacker conveyor after clearing a jam. The pop-up roller became hung up on the frame of the roller flight conveyor. The employee s hand then became caught between the pop-up roller and the belts on the drop table. The employee sustained an avulsion to their right hand excluding the fingers. The employee was hospitalized and required surgery.
On May 6, 2025, a temporary employee was loading a sheet of fiberglass between two rollers on a roofing material machine. The top roller was not rotating. The roller fell and pinched his left ring fingertip, causing a partial amputation of the finger that required surgery.
An employee was about to dump sand from a hopper, raised on the forks of a forklift. As the hopper's weight shifted forward and it began to dump, the employee's left middle finger was pinched between the forklift fork and the metal frame of the hopper. The fingertip was crushed, and the employee underwent a medical amputation at the first knuckle.
An employee was helping to lift the grating from a floor draining system when the grating slipped and landed on his hand, resulting in the amputation of his right middle finger at the first joint.
During a workshop meeting in a hotel, an employee heard a drilling noise, so he walked outside to see what it was. An explosion occurred (possible gas line) and his face, ear, and hair were burned. He also fell and sustained a pelvic fracture.
An employee was using a tool to remove a rag from a roll on the tube mill. The roll pulled the tool and the employee's right hand into the roll, resulting in a partial amputation of the little finger and a fracture to the index finger.