Injured by slipping or swinging object held by other person · Amputations
At a glance
Federal OSHA recorded a severe workplace injury
at WestRock Hodge Mill, 100 Mill Street, HODGE, LOUISIANA 71247
on — Amputations, affecting the finger(s), fingernail(s), unspecified.
Final narrative
A maintenance mechanic was working with another employee to fix the recycle waste conveyor chain. They needed to knock out a bushing on the conveyor chain using a steel rod and bull pin. The employee working with the mechanic struck the metal rod while the mechanic's finger was between the rod and the bull pin. The mechanic's right middle finger was partially amputated.
AmputationFinger(s), fingernail(s), unspecifiedStriking and nailing handtools-power not determined, n.e.c.
An employee was checking a rapper on a recovery boiler precipitator when the rapper rod (weighing approximately 10-15 lbs.) fell from inside the rapper coil assembly and struck the employee on the left middle finger. The employee received a cut/laceration, resulting in a partial amputation of the left middle fingertip with no bone loss.
The injured employee was holding a board that was being cut by another employee. The board kicked back, causing the saw to amputate the employee's left little finger and lacerate their left hand, resulting in nerve damage.
On September 26, 2023, an employee was working in a trench box while a co-worker was lowering a piece of plastic pipe by hand using a rope. The pipe swung and struck the employee's hand, fracturing their right thumb and middle and ring fingers. The employee was hospitalized.
An employee went over to a co-worker's station while the co-worker was using a powered meat knife. As the injured employee was pointing, his right index fingertip was amputated.
Two employees were using a handheld banding tool to make banding tape for tent set-ups. One employee was holding the banding tool and the injured employee was looping a metal clip around the tape. The tool closed while the injured employee's hand was near the banding mechanism. The banding tape caught the employee's right ring finger as it tightened, resulting in a partial amputation.
An employee was holding a branch against a log on the ground to make a wedge while another employee was using a chainsaw to cut the wedge. The saw slipped and struck the employee holding the branch, resulting in a laceration to the right wrist.
More severe injuries in this industry (NAICS 322121)
Tools and parts were being lowered to the ground from an elevated platform in a 5-gallon bucket. The rope being used to lower the bucket failed; the tools and parts fell and lacerated the left forearm and upper left leg of an employee on the ground.
An employee was tracking an infeed belt on a scrap hogger when their right arm was caught between the belt and a roller. The arm was broken and the employee's shoulder was dislocated. The employee was hospitalized.
An employee was working to clear a jam from a paper napkin folder. The ram that advanced the napkins pushed the employee's right arm into the side of the machine, causing several lacerations and a hairline fracture.
An employee was troubleshooting overflowing ink on a printer-slotter machine when their right ring fingertip was caught in a guarded roller, resulting in a partial amputation.
An employee was disconnecting wires in preparation to swap out a refiner motor when they contacted energized equipment and sustained an electrical shock. The employee was hospitalized.
A driver was exiting his vehicle outside the plant gate when his foot slipped on the top step of the truck. He fell to the ground, landed on his left hip and elbow. The employee was hospitalized with a fractured hip/femur.
A security employee was responding to an urgent call from staff regarding a violent patient. The employee tripped and fell on the floor outside of the stairwell. The employee sustained a closed head injury, contusion of the cerebrum without loss of consciousness, and a closed fracture of the distal end of the right radius.
A temporary employee was testing an electrical starter motor. He was placing tape on the starter while the breaker was not engaged, but the starter sent an arc flash that burned his hands and stomach.
An employee was walking on a sidewalk and stubbed his toe on an elevated portion of concrete, causing him to trip and fall. The employee's right knee was dislocated.