Pelletier Manufacturing Inc.

An employee was checking the function of newly installed actuators when they were struck by a pressurized release pipe. The employee suffered fractures to the orbital socket and shoulder, requiring hospitalization.

A ramp in the trunk of a delivery van struck an employee's calf. She suffered a broken leg and was hospitalized.

An employee was completing a service call and looking at a water pump when the pump cover plate struck their forehead. The employee sustained a forehead laceration and fracture requiring hospitalization.

An employee was removing chains from a steel tube. A sorting hook attachment was caught on the staging area cross member. When he raised the chains, the sorting hook snapped back and struck the employee's face causing a fractured jaw.

An employee was in the sawmill basement using a push broom and shovel to clean wood chips and sawdust. The employee's right arm was struck by a wooden board between the wrist and elbow, resulting in a fracture.

An employee was operating a saw when their right hand contacted the blade(s), resulting in amputation of four fingers and a partial thumb amputation.

An employee was using a telehandler to move pallets of pellets from a pod. The employee exited the telehandler to pick up a sacrificial pallet that is placed under the bottom layer of pallets. When the employee turned to pull the pallet away, the top two tiers of the pod fell on him. The employee sustained a fractured ankle, three fractured ribs, and fractured vertebrae.

An employee was loading a piece of wood onto a machine when the wood came out from under the guard and struck their arm, resulting in a fractured arm.

An employee was preparing to replace a belt on a fan drive assembly. He went to manually stop the fan and was caught by the belt. His hand was pulled into the machine and his left little fingertip was amputated.

An employee was cutting remanufactured lumber with a chainsaw when a board fell and struck his left hand, causing his left hand to move off the chainsaw. While he was moving his hand back, the chainsaw kicked back and lacerated the top of his left hand. The employee was hospitalized.

A crew was installing drilled micropiles alongside an outdoor covered deck foundation. The injured employee was working the front of the drill when a loose section of casing dropped onto the tip of a rig wrench and pulled the wrench down to an embedded casing. The employee's left little finger was caught between the rig wrench and the embedded casing and was amputated above the top knuckle.

Two employees were working to change a tire on a mobile slasher saw. The slasher weighs around 2,000 pounds and is towed. Employee 2 was lifting the saw while the injured employee was placing a block of wood under the frame for support. The slasher then lowered onto the block and the injured employee's left thumb was crushed between the slasher frame and the wood block, leading to an amputation at the first knuckle.

An employee was using a metal shear when it amputated the tip of his right index finger.

An employee was using a crane to move a 44-foot, 3,343-pound I-beam. As the beam was moving west, it straightened out (north to south), beginning to swing south toward the northwest corner of a building. The crane then sent the beam southward, directly toward the corner of the building. The beam caught the tips of the employee's left index, middle, and ring fingers against the building. The last joints of the middle and ring fingers were amputated, and the last joint of the index finger was partially crushed.

An employee was standing on a step stool, removing the nuts and bolts from the frame of a solar panel that was being replaced. The employee's cheek made contact with a connector with damaged insulation. The employee was shocked, briefly lost consciousness, and fell to the ground, suffering an injury to the left shoulder.